Abstract:This work proposes a liquid-metal-based calorimetric micro-flow sensor within a polydimethylsiloxane (PDMS) chip. It can measure the flow rate of fluid in microscale channels, with a range as low as several microliters per minute. This in-chip sensor is proposed to solve the issue of detecting the flow rate in microfluidic systems. To make the sensor compatible with PDMS microfluidic chips, low-melting-point gallium-based alloy and bismuth-based (bi-based) alloy are used to make the micro heater and bi-metal thermocouples, for these alloys can be easily injected into a PDMS chip to form electrodes. To minimize heat resistance (or temperature difference) between fluid and the detecting ends of thermocouples, these ends are directly exposed to liquid in the flow channel with the help of a special reversible bonding technology. Thermocouples are connected in parallel to improve the sensor's response. A novel method to bond and electrically connect the sensor to a PCB (print circuit board) is also elaborated. Since the calorimetric flow sensor is sensitive to heating power, fluid temperature and environment cooling, a dimensionless parameter less independent of these factors is deduced from heat transfer theory, and this idea is used in result processing to offset the bad effect. Experiments with pure water show that this sensor can be used to detect flow rates, with a resolution up to 4 μl/min/mV and a range of 12 μl/min in this case, and that at different heating powers, the thermal potential results vary significantly whereas the dimensionless results nearly keep the same. Present work indicates that this sensor has the potential to be integrated into a PDMS microfluidic system and to provide accurate and stable results if a dimensionless method is used in data processing.

Direct Chip Attachment Packaging of a 2-D Thermal Flow Sensor

An Integrated Circuit Compatible Compact Package for Thermal Gas Flowmeters

Design and Testing of a Micro Thermal Sensor for Non-Contact Surface Defect Detection.

Systematic Study of Packaging Designs on the Performance of CMOS Thermoresistive Micro Calorimetric Flow Sensors

High Performance Bidirectional Thermal Gas Flow Sensor of (100) Silicon Single-Sided Fabrication by 45-Tilted Dicing

Design of Thermal Liquid Flow Microsensor

A Low-Cost Integrated Micro System for Flow Velocity and Direction Measurement

Single Chip Sensing of Multiple Gas Flows

Monolithic Integration of a Flexible Micro Thermal Flow Sensor

Design And Realize Of 3d Integration Of A Pressure Sensor System With Through Silicon Via (Tsv) Approach

A numerical investigation of conjugate forced heat transfer for a micro thermal flow sensor

Micro Thermal Flow Sensors/systems on Flexible PCB and Extensive Applications

Characterization and Design Evaluation of Membrane-Based Calorimetric MEMS Sensors for Two-Dimensional Flow Measurement

A two-dimensional flow sensor with integrated micro thermal sensing elements and a back propagation neural network

A Compact Flexible Thermal Flow Sensor for Detecting Two-Dimensional Flow Vector

A Low-Cost Flexible Hot-Film Sensor System for Flow Sensing and its Application to Aircraft

Design and optimization of a TSV 3D packaged pressure sensor for high temperature and dynamic measurement

A Flexible Flow Sensor System And Its Characteristics For Fluid Mechanics Measurements

Embedded Micro-Pin Fin Heat Sink of Two-Phase Liquid Cooling for High Heat Flux 3D ICs

A liquid-metal-based microscale calorimetric in-chip flow sensor for flow rate measuring

Single (111)-Wafer Single-Side Microfabrication of Suspended p + Si/n + Si Thermopile for Tiny-Size and High-Sensitivity Thermal Gas Flow Sensors