Abstract:Amorphous Ni-P coatings were prepared by using pulse reverse plating. The effects of aver-age current density, duty cycle, temperature and concentration of phosphorous acid and sodium citrate on the properties of the coat-ings were studied. Results show that the depositing rate of Ni-P coatings increases with increasing average current density, and the corrosion potential becomes increasingly negative therewith. The surface of the coatings changed from smooth and compact to porous with bubbles or even peelings with increasing average cur-rent density. When the duty cycle rose from 30% to 70%, the amorphous Ni-P alloy coating was transformed into crystalloid, and the corrosion potential became increasingly negative. The Ni-P coating obtained at a duty cycle of 30% had the highest positive corrosion potential and best corrosion resistance. Be-sides , temperature had an effect on the brightness and smoothness of the Ni-P coatings, and the coating obtained at 70℃ had the best appearance and highest positive corrosion potential. Moreo-ver, the surface of the Ni-P coatings was transformed from smooth and compact to incorporated with a large amount of black stripes or peelings with increasing concentration of H3PO3, and the opti-mum concentration of H3 PO3 was 20 ～30 g/L. In addition, the deposition rate of the Ni-P coatings decreased with increasing concentration of sodium citrate, and the corrosion potential be-came increasingly positive therewith, corresponding to increased corrosion resistance.

Effects of NH4F on the deposition rate and buffering capability of electroless Ni–P plating solution

Effects Of Nh4f On Electroless Ni-P Plating Bath And Properties Of Coatings

Effects of Ph Value and Concentration of Solution on P Content and Deposition Rate During Electroless Ni-P Plating on Aluminum Substrate Surface

Effect of electroless deposition on the corrosion resistance property for NdFeB permanent magnets with surface coating of Ni-P alloy

Effects of Ligands on Electroless Ni–P Alloy Plating from Alkaline Citrate–ammonia Solution

CHEMICAL PLATING MECHANISM IN ACID BATHS AND FABRICATION OF Ni-P COATING WITH HIGH P CONTENT

Effect of Ammonium on Low-Temperature Electrodeposition of Ni–P Alloys

Effects of Surfactants in an Electroless Nickel-Plating Bath on the Properties of Ni−P Alloy Deposits

Effects of fluoride ions as electrolyte additives for a PEO/Ni-P composite coating onto Mg alloy AZ31B

Effect of Pulse Reverse Electroplating Technology on the Properties of Amorphous Ni-P Alloy Coating

Electroless Deposition of Ni-Co-P Deposit on NdFeB Permanent Magnets and Its Corrosion Resistance Property

Effects of Yb3+ on the corrosion resistance and deposition rate of electroless Ni–P deposits

Effect of Adding Modes of Plating Solution on Low Phosphorous Electroless Nickel Plating

Improved microhardness and wear resistance of the as-deposited electroless Ni–P coating

Ammonium Fluoride Additive-Modified Interphase Chemistry Stabilizes Zinc Anodes in Aqueous Electrolytes.

Optimization of the Electroplating Process for Amorphous Nickel- Phosphorus Alloy

Effects of NaH2PO2 concentration and deposition potential on microstructural characteristics and corrosion properties of electrodeposited amorphous Fe–P coatings

Effect of nickel immersion pretreatment on the corrosion performance of electroless deposited Ni–P alloys on aluminum

EFFECTS OF DEPOSITION PROCESS ON PHOSPHORUS CONTENT IN ELECTROLESS Ni-P COATINGS

Preparation of Electrodeposited Foam Fe-Ni Alloy Coating with Low Content of Nickel

Preparation of Amorphous Nickel-Phosphorus Alloy Coating by Electroplating