Electrodeposition of amorphous Ni–P coatings onto Nd–Fe–B permanent magnet substrates

C MA,F CAO,Z ZHANG,J ZHANG

DOI: https://doi.org/10.1016/j.apsusc.2006.04.037

IF: 6.7

2006-01-01

Applied Surface Science

Abstract:Decorative and protective Ni–P amorphous coatings were electroplated onto NdFeB permanent magnet from an ortho-phosphorous acid contained bath. The influences of the main electroplating technological parameters including current density, bath pH, bath temperature and H3PO3 on the structure and chemical composition of Ni–P coatings were investigated by potentiodynamic polarization and electrochemical impedance spectroscopy (EIS) techniques in conjunction with X-ray diffraction (XRD), scanning transmission electron microscopy (SEM) and X-ray energy-dispersive spectrometry (EDX). The optimized amorphous Ni–P coated NdFeB can stand for ca. 180h against neutral 3.0wt.% NaCl salt spray without any pitting corrosion. Meanwhile, the results also showed that large phosphorous content is the precondition for Ni–P coatings to possess the amorphous structure, but too much high phosphorous content can damage the amorphous structure due to the separation of superfluous P from Ni2P/Ni3P and the resultant formation of multi-phase coatings (such as Ni2P–P).