Abstract:In terms of the mechanisms of methanol synthesis from synthesis gas and methanol dehydration, it was predicted that the yield of dimethyl ether (DME) would be greatly increased if the inter-dispersion of the oxide particles in the catalyst was enhanced. For comparison, 4 methods-- bi-hydrolysis precipitation and three other methods were used to prepare the catalysts: (1) Low-dispersion mixing: A commercial Cu/Zn/Al methanol catalyst having a size range of 20--40 mesh was mechanically mixed with a dehydration catalyst {gamma}-alumina with the same size range; (2) High-dispersion mixing: The two catalysts used in 1 were ground together to {minus}200 mesh and pelletized and then crushed to 20--40 mesh; (3) Co-precipitation impregnation as reported in a cited reference; (4) Bi-hydrolysis precipitation: An aqueous solution of mixed nitrates of copper and zinc and an aqueous solution of NaAlO{sub 2} were simultaneously dropped into a beaker containing some deionized water. A precipitate was formed which was filtered, washed, dried and calcined. The particle size of the catalysts prepared by methods 3 and 4 charged into the reactor were in the same range as those by methods 1 and 2. Catalysts prepared by methods 1, 2, 3 and 4 are designated as Cat-1, Cat-2, Cat-3more » and Cat-4 respectively. The inter-dispersion of the oxides particles were in the order of Cat-1 < Cat-2 < Cat-3 < Cat-4. The catalysts were evaluated for activity in a tubular flow reactor with a feed having a mole composition of H{sub 2}/CO/CO{sub 2} = 64/31/5 under 270 C, 3 MPa and a space velocity of 2000 h{sup {minus}1}. Results are presented in a table and briefly discussed.« less

Liquid-phase preparation of catalysts used in slurry reactors to synthesize dimethyl ether from syngas: Effect of heat-treatment atmosphere

Catalytic performance of CuZnAl slurry catalyst prepared by complete liquid phase technology for direct synthesis DME from syngas

Complete liquid-phase preparation and characterization of Cu-Zn-Al-Zr slurry catalysts for synthesis of dimethyl ether

The Structure Properties of CuZnAl Slurry Catalysts Prepared by a Complete Liquid-Phase Method and its Catalytic Performance for DME Synthesis from Syngas

Complete Liquid Phase Preparation and Characterization of CuZnAlSi Catalysts for DME Synthesis in Slurry Reactor

Liquid-phase preparation of CuO/ZrO2 catalyst used in slurry reactors and its catalytic activity for CO hydrogenation

Liquid-Phase Preparation of Dme Slurry Catalysts Using Pseudo-Boehmite As Aluminum Source

Research on Si–Al Based Catalysts Prepared by Complete Liquid-Phase Method for DME Synthesis in a Slurry Reactor

Effect of Surfactant on Structure and Performance of Catalysts for DME Synthesis in Slurry Bed

Dimethyl Ether Synthesis from CO2 Hydrogenation on a CuO−ZnO−Al2O3−ZrO2/HZSM-5 Bifunctional Catalyst

Kinetic Study of Complete Liquid-Phase Catalyst for Dimethyl Ether Synthesis

Effect of Composition of Raw Materials on Structure and Dimethyl Ether Synthesis Activity of Cu-Zn-Al Catalyst Prepared by Complete Liquid Phase Method

Mechanism and catalytic performance for direct dimethyl ether synthesis by CO2 hydrogenation over CuZnZr/ferrierite hybrid catalyst

Xps Study on Cuznal Catalysts Prepared by Different Methods for Direct Synthesis of Dimethyl Ether

Optimizing CO 2 Hydrogenation to DME through Tailored Interfacial Interactions: Weakening Synergy in CuZnZr and Al-Modified SBA-15 Catalysts

C2–C4 Hydrocarbons Synthesis from Syngas over CuO–ZnO–Al2O3/SAPO‐34 Bifunctional Catalyst

99/00320 Effect of oxide dispersion in a bifunctional catalyst on the formation of dimethyl ether

A novel liquid-phase technology for the preparation of slurry catalysts

HYDROGENATION ON SUPPORTED Cu-Mn-ZnOX CATALYST--EFFECT OF PREPARATION METHOD AND REACTION CONDITIONS

Effect of copper content on Cu–Mn–Zn/zeolite-Y catalysts for the synthesis of dimethyl ether from syngas

Single-step dimethyl ether synthesis on a Cu/ZnO/Al_2O_3/ZrO_2+γ-Al_2O_3 bifunctional catalyst in slurry reactor