Abstract:In terms of the mechanisms of methanol synthesis from synthesis gas and methanol dehydration, it was predicted that the yield of dimethyl ether (DME) would be greatly increased if the inter-dispersion of the oxide particles in the catalyst was enhanced. For comparison, 4 methods-- bi-hydrolysis precipitation and three other methods were used to prepare the catalysts: (1) Low-dispersion mixing: A commercial Cu/Zn/Al methanol catalyst having a size range of 20--40 mesh was mechanically mixed with a dehydration catalyst {gamma}-alumina with the same size range; (2) High-dispersion mixing: The two catalysts used in 1 were ground together to {minus}200 mesh and pelletized and then crushed to 20--40 mesh; (3) Co-precipitation impregnation as reported in a cited reference; (4) Bi-hydrolysis precipitation: An aqueous solution of mixed nitrates of copper and zinc and an aqueous solution of NaAlO{sub 2} were simultaneously dropped into a beaker containing some deionized water. A precipitate was formed which was filtered, washed, dried and calcined. The particle size of the catalysts prepared by methods 3 and 4 charged into the reactor were in the same range as those by methods 1 and 2. Catalysts prepared by methods 1, 2, 3 and 4 are designated as Cat-1, Cat-2, Cat-3more » and Cat-4 respectively. The inter-dispersion of the oxides particles were in the order of Cat-1 < Cat-2 < Cat-3 < Cat-4. The catalysts were evaluated for activity in a tubular flow reactor with a feed having a mole composition of H{sub 2}/CO/CO{sub 2} = 64/31/5 under 270 C, 3 MPa and a space velocity of 2000 h{sup {minus}1}. Results are presented in a table and briefly discussed.« less

Effect of Composition of Raw Materials on Structure and Dimethyl Ether Synthesis Activity of Cu-Zn-Al Catalyst Prepared by Complete Liquid Phase Method

The Structure Properties of CuZnAl Slurry Catalysts Prepared by a Complete Liquid-Phase Method and its Catalytic Performance for DME Synthesis from Syngas

Complete liquid-phase preparation and characterization of Cu-Zn-Al-Zr slurry catalysts for synthesis of dimethyl ether

Xps Study on Cuznal Catalysts Prepared by Different Methods for Direct Synthesis of Dimethyl Ether

Complete Liquid Phase Preparation and Characterization of CuZnAlSi Catalysts for DME Synthesis in Slurry Reactor

Catalytic performance of CuZnAl slurry catalyst prepared by complete liquid phase technology for direct synthesis DME from syngas

Effect of Surfactant on Structure and Performance of Catalysts for DME Synthesis in Slurry Bed

Promoting effect of an aluminum emulsion on catalytic performance of Cu-based catalysts for methanol synthesis from syngas

Effect of copper content on Cu–Mn–Zn/zeolite-Y catalysts for the synthesis of dimethyl ether from syngas

Effect of zinc source on the ethanol synthesis from syngas over a slurry CuZnAl catalyst

Research on Si–Al Based Catalysts Prepared by Complete Liquid-Phase Method for DME Synthesis in a Slurry Reactor

Effect of preparation methods of aluminum emulsions on catalytic performance of copper-based catalysts for methanol synthesis from syngas

Influence of the precursors in CuZnAl slurry catalyst preparation by the complete liquid phase for the ethanol synthesis from syngas

Kinetic Study of Complete Liquid-Phase Catalyst for Dimethyl Ether Synthesis

99/00320 Effect of oxide dispersion in a bifunctional catalyst on the formation of dimethyl ether

Surface Properties of CuO/ZnO/Al_2O_3 Catalyst for Methanol Synthesis in Slurry Reactor

Preparation, Structure And Performance Of [Cuo-Zno-Al2o3]/[Hzsm-5] Core-Shell Bifunctional Catalysts For One-Step Synthesis Of Dimethyl Ether From Co2+H-2

Liquid-phase preparation of catalysts used in slurry reactors to synthesize dimethyl ether from syngas: Effect of heat-treatment atmosphere

A NOVEL PREPARETION OF Cu-Mn CATALYSTS FOR DIMETHYL ETHER SYNTHESIS FROM SYNGAS

Effect of the Addition of Manganese and Zinc on the Properties of Copper-Based Catalyst for the Synthesis of Syngas to Dimethyl Ether