Simulation of a Charged Al2O3 Film as an Assisting Passivation Layer for a-Si Passivated Contact P-Type Silicon Solar Cells
Tian Pu,Honglie Shen,Quntao Tang
DOI: https://doi.org/10.1007/s12633-021-01105-4
IF: 3.4
2021-04-19
Silicon
Abstract:In this paper, a charged Al2O3 tunneling film as an assisting for amorphous Si (a-Si) passivated contact layer is proposed and theoretically simulated for its potential application in improving a-Si passivated contact p-type (a-PC-p) solar cell. The concept is based on an Ag/n+ c-Si/p c-Si/Al2O3/p+ a-Si/Al structure. The key feature is the introduction of a charged Al2O3 layer, which facilitates the tunneling of holes through an Al2O3 insulator layer accompanied by the reduction of interface defect density (Dit). The negative charge in the Al2O3 layer makes the energy band of p-type c-Si bend upward, realizing the accumulation of holes and repelling of electrons at the c-Si/a-Si interface simultaneously. The influence of interface negative charges (Qit) between a-Si and c-Si, Al2O3 thickness, Al2O3 bandgap, interface defect density (Dit) at the a-Si/c-Si interface are systematically investigated on the output parameters of a-PC-p cells. Inserting a charged Al2O3 film between the c-Si/a-Si interface, a + 4.2% relative efficiency gain is predicted theoretically compared with the a-PC-p cells without the Al2O3 layer. Subsequently, the device performance under various temperatures is simulated, and the insertion of a charged Al2O3 layer obviously decreases the Pmax temperature coefficient from −0.336% /°C to −0.247% /°C, which is analogous to that of Heterojunction with Intrinsic Thin layer (HIT) solar cell. The above results demonstrate a better temperature response for a-PC-p cells with a charged Al2O3 layer, paving a road for its potential application in high-efficiency and high thermal stability a-PC-p solar cells.
materials science, multidisciplinary,chemistry, physical