Abstract:The dihedral angle errors (DAEs) and flatness errors of a nonideal corner cube retroreflector (CCR) determine a ground-based optical instrument's received optical power. The smaller tolerance of the dihedral angle with lower divergence is theoretically beneficial to improving the received optical power but could increase the difficulty in the fabrication and bring about a higher manufacturing cost. We propose a new method that is just dependent on the curvature radius of the front-face (CROF) of the CCR to compensate for the divergence of the output beam from the CCR caused by the DAEs. We build up a mathematical model of the received optical power based on the far-field diffraction pattern (FFDP) of the CCR and the layout of the optical instrument and investigate the effects of the DAEs and the CROF on the FFDP and the received optical power for both the coated and uncoated CCRs. Meanwhile, we present a fitting equation between the compensative CROF and the DAEs based on the principle of maximizing the received optical power. The results demonstrate that the compensative CROF has no dependence on whether the reflecting-faces of the CCR are coated or not and is inversely proportional to the absolute value of DAEs. The received optical power is promptly enhanced by utilizing the compensative CROF. Therefore, it is more feasible to improve the received optical power of the ground-based optical instrument by manipulating the CROF of the CCR rather than the DAEs.

Measurement for 90-deg error of dihedral angles of glass cubes

Study of the Method for Measuring Four-Degree-of-Freedom Geometric Errors of a Linear Stage

A Straightness Measurement System Using a Single-Mode Fiber-Coupled Laser Module

A Novel Method To Enhance The Sensitivity For Two-Degrees-Of-Freedom Straightness Measurement

A Novel Method to Simultaneously Measure the Straightness

Analyzing characteristic of the cube-corner retroreflector applied to laser straightness measurement

One-Dimensional Angle Measurement Error Calibration Technique for Fiber Optic Gyroscope

Four Degree-Of-Freedom Geometric Error Measurement System with Common-Path Compensation for Laser Beam Drift

Novel Enhancing Resolution Method for Measurement Straightness Error

Simultaneous Measuring Method Of Linear Guide Geometric Errors In Four-Degrees Of Freedom

A New Optical Angle Measurement and Compensation

Digital testing of transmitted wavefront distortion for micro-optics

Aberration Calibration in High-Na Spherical Surfaces Measurement on Point Diffraction Interferometry

Influences on the Deflection Angle of the Pentagonal Prism Due to Dithering and Fabrication Angles Error

Universal Interferometer Based on Dynamically-Adjusted Fringe Periods

Research on Two Optical Methods for Aspheric Measurement

Adjustment on the Received Optical Power of a Ground-Based Optical Instrument by a Corner Cube Retroreflector with a Curved Front-Face.

Error impact analysis and experimental research for absolute testing of spherical surfaces

High-Accuracy Method for Measuring Two-Dimensional Angles of A Linear Guideway

Measurement of Straightness Without Abbe Error Using an Enhanced Differential Plane Mirror Interferometer

Measuring Corner Cube Reflectors Through Ray Tracing Of A Reflected Wavefront