Abstract:The dihedral angle errors (DAEs) and flatness errors of a nonideal corner cube retroreflector (CCR) determine a ground-based optical instrument's received optical power. The smaller tolerance of the dihedral angle with lower divergence is theoretically beneficial to improving the received optical power but could increase the difficulty in the fabrication and bring about a higher manufacturing cost. We propose a new method that is just dependent on the curvature radius of the front-face (CROF) of the CCR to compensate for the divergence of the output beam from the CCR caused by the DAEs. We build up a mathematical model of the received optical power based on the far-field diffraction pattern (FFDP) of the CCR and the layout of the optical instrument and investigate the effects of the DAEs and the CROF on the FFDP and the received optical power for both the coated and uncoated CCRs. Meanwhile, we present a fitting equation between the compensative CROF and the DAEs based on the principle of maximizing the received optical power. The results demonstrate that the compensative CROF has no dependence on whether the reflecting-faces of the CCR are coated or not and is inversely proportional to the absolute value of DAEs. The received optical power is promptly enhanced by utilizing the compensative CROF. Therefore, it is more feasible to improve the received optical power of the ground-based optical instrument by manipulating the CROF of the CCR rather than the DAEs.

Analyzing characteristic of the cube-corner retroreflector applied to laser straightness measurement

Analysis of Reflection Property of Cube-corner Retroreflector with Vector Expression

A Straightness Measurement System Using a Single-Mode Fiber-Coupled Laser Module

By vector analysis the rectangular angle error influence on characteristics of the beam of cube-corner retroreflector

Measuring Straightness Method with Common Path Compensation for Laser Drift

A Novel Method To Enhance The Sensitivity For Two-Degrees-Of-Freedom Straightness Measurement

Study of the Method for Measuring Four-Degree-of-Freedom Geometric Errors of a Linear Stage

Novel Enhancing Resolution Method for Measurement Straightness Error

A Novel Method to Simultaneously Measure the Straightness

Study on the Analysis for Error in Triangular Laser Measurement and the Method of Improving Accuracy

Research on Far-Field Diffraction of Cube-Corner Retroreflector in the Satellite Laser Ranging System

Adjustment on the Received Optical Power of a Ground-Based Optical Instrument by a Corner Cube Retroreflector with a Curved Front-Face.

Error Correction Of Laser Scanning System For Reverse Engineering

Analysis of Effects of Retroreflector Motion Errors on Measurement Accuracy of a Homodyne Interferometer

Analysis and Measurement for the Optical Error of the Cat's Eye Retro-Reflector

Measuring Corner Cube Reflectors Through Ray Tracing Of A Reflected Wavefront

Optical Error Of Cat'S Eye Retro-Reflector And Its Correction

Straightness Measurement Based On Phase Sensitive Detection Technique

Optical Error Analysis in the Laser Tracking Measure System

Calibration method of the right-angle error of a hollow corner-cube retroreflector based on an independent autocollimator

The Effect of Optical Corner Cubes' Asymmetry on Angle Measurement of Optical Wedge