Abstract:The rapid development of modern science and technology puts forward higher and higher requirements for displacement measurement. As a non-contact measurement technology, laser ranging has played an important role in various fields for the unique advantages and has become a hot topic in the field of measurement research. At present, there are little research on high-precision displacement measurement at medium and long distance, the needs of which are widespread in practical application, so this work has important value. Among various laser ranging technologies, the laser triangulation method has the advantages of high-speed, high precision, simple structure, etc. Therefore, this paper chooses the direct laser triangulation method to carry out the research after analyzed the common types of laser triangulation system. In view of the requirements of high-precision displacement measurement requirements at medium and long distance, this article discussed the design of laser triangulation measuring system and the selection of structural parameters. Then we proposed a direct laser triangulation measurement structure under Scheimpflug conditions. This system selects PSD displacement transducer to collect the position information of the scattered light spot. After that, this paper discusses the principle of laser triangulation distance measurement and simulates the system. Then the influence of different parameters on high-precision displacement measurement and the relationship between them are investigated. Based on the research talked above, we got a set of structural parameters of the displacement measurement system. The measurement accuracy can be ~micron with the working distance of 500mm.

Measuring Straightness Method with Common Path Compensation for Laser Drift

Laser Collimation Method Based on Differential Compensating Beam Drift

Four Degree-Of-Freedom Geometric Error Measurement System with Common-Path Compensation for Laser Beam Drift

A Straightness Measurement System Using a Single-Mode Fiber-Coupled Laser Module

Study of the Method for Measuring Four-Degree-of-Freedom Geometric Errors of a Linear Stage

Analyzing characteristic of the cube-corner retroreflector applied to laser straightness measurement

A Novel Method To Enhance The Sensitivity For Two-Degrees-Of-Freedom Straightness Measurement

A Novel Method to Simultaneously Measure the Straightness

Novel Enhancing Resolution Method for Measurement Straightness Error

High-Accuracy Method for Measuring Two-Dimensional Angles of A Linear Guideway

Roll angle measurement based on common path compensation principle

Simultaneous Measuring Method Of Linear Guide Geometric Errors In Four-Degrees Of Freedom

Present Status of High Precision Laser Displacement Sensor Based on Triangulation

High-precision laser alignment technique based on spiral phase plate

Method for Active Spatial Alignment and Stabilization of Laser Beams in Multi-Beam Systems

Vision-Based Position Deviation Measurement of Rail Corrugation Chord Measuring Points under Bi-Linear Laser Assistance

A High-Precision Laser Displacement Measurement System

Development of a simple system for simultaneously measuring 6DOF geometric motion errors of a linear guide.

Small-angle measurement in laser autocollimation based on a common-path compensation method

Common-path design criteria for laser datum based measurement of small angle deviations and laser autocollimation method in compliance with the criteria with high accuracy and stability.

Noise Reduction of Air Turbulence Via Thequasi-Common-path Method.