Abstract:The laser alignment technique is widely used in the measurement of straightness due to its unique capabilities of non-contact detection, fast response and high accuracy. By coupling the laser beam into a single-mode fiber, traditional alignment method can be greatly improved, since the emitting beam from the fiber basically won’t be affected by the variation of the incident intensity distribution. However, such method still suffers from errors caused by the vibration of the emitting fiber end and air turbulence. In this paper, the traditional alignment reference, which is the centroid of the intensity distribution, is replaced by center of the dark spot in a diffraction pattern, by adding a spiral phase plate (SPP) into the optical path. The center of the dark spot is proved to be stationary when the laser beam drifts. The far-field diffraction model of SPP is theoretically analyzed in detail. In the calibration experiments, the detected position data of the scanned CCD is highly linear with a correlation coefficient of 0.99999. The system is guaranteed with outstanding stability by a series of experiments, in which the standard deviation of the x and y coordinates are respectively only 7.0% and 33.7% in short-term tests and 20.3% and 25.3% in long-term tests. With simple configuration, the proposed system demonstrates satisfying performance in laser alignment.

Analyzing characteristic of the four-quadrant detector applied to laser alignment

A quadrant detector based laser alignment method with higher sensitivity

Study on Background Light Influences on Four-quadrant Detector

Analyzing characteristic of the cube-corner retroreflector applied to laser straightness measurement

Theoretical Analysis Of The Gauge Laser Sensor And Several Design Parameters

High-precision laser alignment technique based on spiral phase plate

Present Status of High Precision Laser Displacement Sensor Based on Triangulation

Research on the Gauge Sensor Laser Spot

Four Degree-Of-Freedom Geometric Error Measurement System with Common-Path Compensation for Laser Beam Drift

Study of the Method for Measuring Four-Degree-of-Freedom Geometric Errors of a Linear Stage

Laser Collimation Method Based on Differential Compensating Beam Drift

Simultaneous Measuring Method Of Linear Guide Geometric Errors In Four-Degrees Of Freedom

Research on a Novel Laser Displacement Sensor used for Gauge Measurement

Calibration of Laser Beam-Direction for Point Laser Sensors

Airborne Laser Communication System with Automated Tracking

A Pulsed Ultraviolet Laser Positioning System Based on 4H-SiC Four-Quadrant Photodetectors

A New Optical Angle Measurement and Compensation

Research on Influencing Factors of Detection Accuracy Based on Laser Seeker

Study on the Influence of Random Phase Interference on the Positioning Performance of a Four-Quadrant Detector

A Spot Position Scheme on Quadrant Detector for Space-Borne Laser Communication System

The design of detector arrays for laser alignment systems