Abstract:This work presents our recent research and development of environment-friendly MEMS fabrication technology based on an eco-friendly silicon deep reactive ion etching (D-RIE), and polymer-MEMS utilizing hot embossing process. In order to show the capability of this ‘Green’ fabrication technology, several typical MEMS devices have been fabricated successfully. Regarding silicon dry etching technology, the often-used gas SF6 which has very high Global Warming Potentials (GWP) should be replaced by other lower GWP gases, such as Ar/F2. First, the gases were selected with consideration of the simple handle and less danger. Then, Si etching experiments corresponding to these gases were performed and analyzed systematically to find out the most suitable process which can reduce or replace SF6 gas. Furthermore, the etching rate improvement was also studied based on process’s real-time monitoring and feed-back control technology to optimize the timing of deposition and etching steps (Bosch process); therefore, bias RF power can be smartly controlled during the process. In polymer-MEMS technology, we have developed a novel fabrication of a monolithic PMMA MEMS devices utilizing hot embossing, surface-activated direct bonding, polishing, and elliptical vibration cutting processes. The robustness and capability of the method are demonstrated through the fabrication of sophisticated PMMA freestanding micro structures and devices. An efficient technique using reinforcement material to protect the PMMA microstructures during release process was proposed. Small Young’s modulus and high thermal expansion of polymer are the advantages for electrostatic and thermal actuators, respectively, because it will require less power than silicon counterparts to produce the same displacement. All PMMA acceleration sensor, actuators and mirror device have been fabricated to shows the advantages of polymer-MEMS technology. Fig. 1 shows typical MEMS devices made of PMMA polymer by using our polymer-MEMS fabrication process.

Manufacturing Miniature Si-Based Ceramic Rotors by Micro Reaction Sintering

Manufacturing Silicon Carbide Microrotors by Reactive Hot Isostatic Pressing within Micromachined Silicon Molds

Fabrication of Reaction-Sintered SisN_4 Ceramic Microrotors

Fabrication of Si3N4 micro-components by a combined microfabrication process

Fabrication of Si<sub>3</sub>N<sub>4</sub> Micro-Components by a Combined Microfabrication Process

Silicon Carbide Micro-Reaction-Sintering Using Micromachined Silicon Molds

Optimization of Microstructure to Improve Si3n4 Ceramics with Thermal Conductivity and Mechanical Properties: Effect of Si and Α-Si3n4 Powder Composition

One-pot microfluidic fabrication of micro ceramic particles

Ceramic and Metal Additive Manufacturing of Monolithic Rotors From Sialon and Inconel and Comparison of Aerodynamic Performance for 300W Scale Microturbines

Microfabrication Technology of Three-Dimensional Microdevices and Their Mems Applications

Fabrication and Characterization of Sic Rod-Particulate-Reinforced Reaction-Bonded Si3n4 Composites

Development of Thermoelectric Microdevices by Combining Materials Processing and Silicon Micromachining Technology

Microfabrication of thermoelectric materials by silicon molding process

Fabrication Methods for Microscale 3D Structures on Silicon Carbide

3D printing of dense structural ceramic microcomponents with low cost: Tailoring the sintering kinetics and the microstructure evolution

Customized Nanostructured Ceramics via Microphase Separation 3D Printing

Environment Friendly MEMS Process

Silicon-based micro electrostatic motors

Si 3 N 4 ceramics with embedded microchannel structures fabricated by high-precision additive manufacturing based on computational fluid dynamics simulations

Fabricating Processes Of Free-Standing Silicon Nitride Thin Film For Mems Devices