Abstract:Ellipsoidal head is a common end closure of pressure vessel. Plastic collapse is a crucial failure mode considered in the design of ellipsoidal head subjected to internal pressure. Internally pressurized ellipsoidal head tends to be hemisphere (geometric strengthening) due to the effect of material hardening before plastic collapse occurs, which enhances load carrying capacity of ellipsoidal head. However, in the current pressure vessel codes such as ASME BPVC.VIII.1 and BPVC.VIII.2, EN 13445-3, and Chinese codes GB/T 150.3 and JB 4732, design methods based on linear elastic or perfectly-plastic theory are used to prevent plastic collapse of ellipsoidal head, leading to conservative design. Therefore, we developed a new method for preventing plastic collapse of ellipsoidal head under internal pressure, considering the effects of material hardening and geometric strengthening. The new method was developed on basis of our previous extensive work on finite element analysis and experiments for plastic collapse of internally pressurized ellipsoidal heads. The new method provides sufficient margin of safety by checking against the experimental bursting results of full-scale ellipsoidal heads with various geometries, various material types and various manufacturing methods. Compared with the design methods in the current pressure vessel codes, the new method shows an advantage of economy. This new method had been approved by China Standardization Committee on Boilers and Pressure Vessels, and at present it has been introduced into the Chinese pressure vessel code.

Plastic Analysis Methods for Design by Analysis of Pressure Vessels

Advances in "design by Analysis" Methods for Pressure Vessels

Foundation of Plasticity for Design by Analysis of Pressure Vessels

BURST FAILURE ANALYSIS OF PLASTIC ANISOTROPIC THICK-WALLED CYLINDRICAL VESSELS SUBJECTED TO COMBINED PRESSURES

Plastic Limit Load Analysis for Pressure Pipe with Incomplete Welding Defects Based on the Extended Net Section Collapse Criteria

Plastic Limit Load Analysis of Pressure Pipes Containing Incomplete Welding Defects under Combined Loadings

Safety analysis of pressure piping containing incomplete penetration under combined loads

Plastic Collapse Analysis of Thin-Walled Pipes Based on Unified Yield Criterion

The Method of Design by Analysis for Cylindrical Pressure Vessels with Spherically Dished Head

PLASTIC ANALYSES OF STRUCTURES AND FAILURE ASSESSMENT OF PRESSURE VESSELS AND PIPING WITH VOLUMETRIC DEFECTS

Burst Pressure of Pipelines with Plastic Anisotropy under Combined Internal and External Pressures

A New Pressure Vessel Design by Analysis Method Avoiding Stress Categorization

Calculations of Plastic Collapse Load of Pressure Vessel Using FEA

A New Generation Code for Design by Analysis of Pressure Vessels——Introduction of ASME Ⅷ-2 2007 Edition

Direct Route of Design by Analysis

A New Method for Preventing Plastic Collapse of Ellipsoidal Head under Internal Pressure

Plastic load analysis of tooth-locked quick closure pressure vessel using the 5% maximum principal strain rule

Introduction for Design-by-analysis of CEN's Unfired Pressure Vessel

Dual Assessment Criterion and Its Programmed Application of Collapse Failure of Pressure Vessels

Theoretical Assessment of Burst Failure of Internally Pressurized Defect-Free Pipelines with Plastic Anisotropy

Reliability Assessment of Pressure Vessel Design Methods