Abstract:Ellipsoidal head is a common end closure of pressure vessel. Plastic collapse is a crucial failure mode considered in the design of ellipsoidal head subjected to internal pressure. Internally pressurized ellipsoidal head tends to be hemisphere (geometric strengthening) due to the effect of material hardening before plastic collapse occurs, which enhances load carrying capacity of ellipsoidal head. However, in the current pressure vessel codes such as ASME BPVC.VIII.1 and BPVC.VIII.2, EN 13445-3, and Chinese codes GB/T 150.3 and JB 4732, design methods based on linear elastic or perfectly-plastic theory are used to prevent plastic collapse of ellipsoidal head, leading to conservative design. Therefore, we developed a new method for preventing plastic collapse of ellipsoidal head under internal pressure, considering the effects of material hardening and geometric strengthening. The new method was developed on basis of our previous extensive work on finite element analysis and experiments for plastic collapse of internally pressurized ellipsoidal heads. The new method provides sufficient margin of safety by checking against the experimental bursting results of full-scale ellipsoidal heads with various geometries, various material types and various manufacturing methods. Compared with the design methods in the current pressure vessel codes, the new method shows an advantage of economy. This new method had been approved by China Standardization Committee on Boilers and Pressure Vessels, and at present it has been introduced into the Chinese pressure vessel code.

Plastic load analysis of tooth-locked quick closure pressure vessel using the 5% maximum principal strain rule

Unique Design of Tooth-Locked Quick Closure Pressure Vessel Based on the Whole Finite Element Stress Analysis

Unified Plastic Limit Solution for Thick-Walled Cylinder with Size Effect

Numerical Study of CFRP-Bonded Pressure Pipes Subject to Impact Load

Safety analysis of pressure piping containing incomplete penetration under combined loads

Stress Analysis and Assessment of Stream Setting Vessel Based on Elastic Contact Element Method

A 5% Maximum Principal Strain Criterion to Prevent Gross Plastic Deformation

Plastic Limit Load Analysis of Pressure Pipes Containing Incomplete Welding Defects under Combined Loadings

Plastic Limit Load Analysis for Pressure Pipe with Incomplete Welding Defects Based on the Extended Net Section Collapse Criteria

Limit pressure and design criterion of cylindrical pressure vessels with nozzles

Research On Safety Assessment Method For Pressure Pipe With Incomplete Welding Defects Under Complicated Loadings

Plastic Analysis Methods for Design by Analysis of Pressure Vessels

A New Method for Preventing Plastic Collapse of Ellipsoidal Head under Internal Pressure

A New Pressure Vessel Design by Analysis Method Avoiding Stress Categorization

Engineering assessment method for LBB stability analysis in pressure vessels and pipes

Advances in "design by Analysis" Methods for Pressure Vessels

Calculations of Plastic Collapse Load of Pressure Vessel Using FEA

Theoretical Assessment of Burst Failure of Internally Pressurized Defect-Free Pipelines with Plastic Anisotropy

Strength Margin Analysis for Austenitic Stainless Steel Pressure Vessels

Plastic Limit Analysis Of Modified 9cr-1mo Steel Pressure Vessel Containing Volume Defect With Creep Damage Law

Modeling and Optimization of Ultra High Pressure Vessel with Self-Protective Flat Steel Ribbons Wound and Tooth-Locked Quick-Actuating End Closure