Abstract:Traditional coiled tubing radial drilling with the same diameter cannot support deep and ultra-deep wells for high-pressure hydraulic jet drilling due to small diameter and sizeable hydraulic loss over long distances. The novel downhole movable pipe radial hydraulic drilling technique extracts a small diameter high-pressure injection pipe from the (tubing pipe) oil pipe and then drills it horizontally into the formation to form a radial hole. Dynamic sealing is the core of this technology, which achieves high-pressure fluid sealing while ensuring the injection pipe smoothly slides out of the oil pipe. A sealing tool is designed between the tubing and the injection pipe to prevent the leakage of high-pressure fluid. In this paper, the finite element model of the sealing tool was established, and the deformation and stress of the sealing tool under different interference and fluid pressure were simulated and analyzed. The relationship between stress distribution and contact pressure under the corresponding conditions was obtained. The results show that the von Mises stress increases significantly with the increase in fluid pressure under certain interference conditions. When the fluid pressure was 35 MPa, 52 MPa, and 70 MPa, the maximum von Mises stress was 29.65 MPa, 30.87 MPa, and 32.47 MPa, respectively, within a reasonable range. The stress peak area changes simultaneously, indicating that the possible damage location changes with the fluid pressure change. The maximum contact pressure between the sealing ring and the smooth rod increases with interference and fluid pressure, which always meets the sealing conditions. A laboratory test bench was built to test the high-pressure sealing performance of the sealing tool. Combined with the simulation data and test results, the downhole continuous rod dynamic sealing tool was modified to provide theoretical guidance for practical application.

Research on Radial Gap of Double-cone Structure in High Pressure Vessel

Modeling and analyzing on pressure distribution of plane port pair based on disk-shape gap

Experimental Study on Dynamic Sealing Performance under High Pressure and High Speed

Comparison of design methods for internally pressurized ellipsoidal head

Investigation on sealing gap between ring gear and case in internal gear machines

Buckling behaviour of imperfect ring-stiffened cone–cylinder intersections under internal pressure

Study on Main Structure Parameters of Large-diameter Double-cone Seal

Design method and research of high temperature gas floating ring seal with slightly variable gap

Design and research on ultra-high pressure sealing structure based on tight plug ring

Seal Contact Performance Analysis of Soft Seals on High-Pressure Hydrogen Charge Valves

Finite Element Analysis of Reciprocating Sealing Component of Radial Single-piston Pump

Exploring Nonlinear Behavior of Gasket Joints in DEF Dosing Units through Finite Element Analysis

Strength investigation on high pressure vessel with hemispherical head thinner than that of cylinder

Sealing Failure Analysis on V-Shaped Sealing Rings of an Inserted Sealing Tool Used for Multistage Fracturing Processes

A Study on the Sealing Performance of Metallic C-rings in Reactor Pressure Vessel

Design and experimental study on full-metal sealing structure of mandrel-type casing hanger

Design and Performance Research of Single Rubber Cylinder for High Pressure Gas Injection Packer

Digital Simulation for Seal Process of Double-cone Ring in Large-sized Ammonia Converter

Performance of a new waterproof system with double sealing gaskets outside bolt hole of segment

Reliability Analysis of Dynamic Sealing Performance in the Radial Hydraulic Drilling Technique

Analysis of Sealing Performance of a Kind of Profiled Rubber Gasket Used in the Radial Contact Seal Structure