Abstract:Crack growth analysis (CGA) was applied to estimate the cycle life of the high-pressure hydrogen equipment constructed by the practical materials of 4340 (two heats), 4137, 4130X, A286, type 316 (solution-annealed (SA) and cold-worked (CW)), and type 304 (SA and CW) in 45, 85 and 105 MPa hydrogen and air. The wall thickness was calculated following five regulations of the High Pressure Gas Safety Institute of Japan (KHK) designated equipment rule, KHKS 0220, TSG R0002, JB4732, and ASME Sec. VIII, Div. 3. We also applied CGA for four typical model materials to discuss the effect of ultimate tensile strength (UTS), pressure and hydrogen sensitivity on the cycle life of the high-pressure hydrogen equipment. Leak before burst (LBB) was confirmed in all practical materials in hydrogen and air. The minimum K-IC required for LBB of the model material with UTS of even 1500 MPa was 170 MPa . mu in 105 MPa. Cycle life qualified 10(3) cycles for all practical materials in air. In 105 MPa hydrogen, the cycle life by K-IH was much shorter than that in air for two heats of 4340 and 4137 sensitive to hydrogen gas embriftlement (HGE). The cycle life of type 304 (SA) sensitive to HGE was almost above 10(4) cycles in hydrogen, while the cycle life of type 316 (SA and CW) was not affected by hydrogen and that of A286 in hydrogen was near to that in air. It was discussed that the cycle life increased with decreasing pressure or UTS in hydrogen. This behavior was due to that K-IH increased or fatigue crack growth (FCG) decreased with decreasing pressure or UTS. The cycle life data of the model materials under the conditions of the pressure, UTS, K-IH, FCG and regulations in both hydrogen and air were proposed quantitatively for materials selection for high-pressure hydrogen storage.

Seal Contact Performance Analysis of Soft Seals on High-Pressure Hydrogen Charge Valves

Review on Hydrogen-Induced Failure of Rubber O-Rings for High Pressure Hydrogen Storage Tanks

Effect of Swelling Behavior of Rubber Rings on the Sealing Performance for 70MPA Hydrogen Pressure Reducing Valves

Sealing performance analysis of rubber O-ring in high-pressure gaseous hydrogen based on finite element method

FLUID DYNAMICS AND CONTACT STRESS ON HARD SEALING SURFACE ANALYSIS OF LNG CRYOGENIC BALL VALVE

Experimental Research and Finite Element Analysis of Seals in the Pressure Compensator

Finite Element Analysis of Sealing Performance of Rubber D-Ring Seal in High-Pressure Hydrogen Storage Vessel

Parametric analysis on multi-stage high pressure reducing valve for hydrogen decompression

Research on the Sealing Mechanism of Split-Liner High-Pressure Hydrogen Storage Cylinders

A review on effect of hydrogen on rubber seals used in the high-pressure hydrogen infrastructure

Mechanical property and sealing performance analysis of the diaphragm compressor cylinder head for the hydrogen refueling station under the mutation impact load

Crack Growth Analysis Of High-Pressure Equipment For Hydrogen Storage

Pressure analysis on two-step high pressure reducing system for hydrogen fuel cell electric vehicle

Study on fretting behavior of rubber O-ring seal in high-pressure gaseous hydrogen

Investigation on High-Pressure Metal Hydride Hydrogen Compressors

Modeling and analysis of minor seal leakages in high-pressure hydrogen valves under extreme environmental temperatures

Fretting Characteristics of Rubber X-Ring Exposed to High-Pressure Gaseous Hydrogen

A study on 70MPa metal hydride hydrogen compressor

Parametric study on Tesla valve with reverse flow for hydrogen decompression

Numerical Analysis of Flow and Temperature Characteristics in a High Multi-Stage Pressure Reducing Valve for Hydrogen Refueling Station

Hydrogen Decompression Analysis by Multi-Stage Tesla Valves for Hydrogen Fuel Cell