Abstract:Tubesheet-flanged joint is usually used in some situations for its detachability, such as some small scale heat exchangers. This type of structure is convenient for maintenance. But leakage will become a major failure mode for flanged joint, especially for heat exchangers with multiple passes. Temperature gradient of different passes may cause non-axisymmetric thermal loading, stress and deformation distribution. In this paper, a detailed three dimensional finite element model of a tubesheet-flanged joint of an oil-water heat exchanger is established with a flexible graphite metallic spiral wound gasket. This kind of gasket has a good compression resilience performance. The compression-unloading curve of gasket under different temperatures are used. The stress and temperature distribution of the joint and gaskets are simulated under preload condition, pressure condition and operation condition. The seating performance are evaluated using gasket compression stress and flange stiffness criteria. The results show that the gasket compression stress distributions under preload and pressure condition are similar. Under operation condition, the gasket compression stress in local area decreases significantly and the gasket compression stress distribution along the circumferential direction becomes non-uniform because of different pass temperature. The Taylor-water method, typically used for flange design, provides a design bolt load for sizing the bolt and flange, does not provide an explicit calculation for the assembly bolt load. At some locations the compression stress is much smaller than minimum seating stress using Taylor-water method to determine bolt preload. However, under preload of half bolt yield strength recommended by ASME PCC-1, all assessment parameters are within the allowable limits.

Digital Simulation for Seal Process of Double-cone Ring in Large-sized Ammonia Converter

Study on Main Structure Parameters of Large-diameter Double-cone Seal

Experimental Research and Finite Element Analysis of Seals in the Pressure Compensator

Experimental Study on Dynamic Sealing Performance under High Pressure and High Speed

Analytical and Experimental Method of Thermal Load Estimation for Seals in Transmission of Vehicle

Finite ElementAnalysis of Sealing Performance and Stress Intensity of the Flange

Sealing Evaluation of Tubesheet-Flanged Joint under Internal Pressure and Non-Axisymmetry Thermal Loading

Design method and research of high temperature gas floating ring seal with slightly variable gap

The Non- Linear Contact Finite Element Analysis of Seal Structure on Large Scale Cutting Tube Machine

The Change of Sealing Property in the Aging Process of NBR Sealing Equipment Based on Finite Element Analysis

EXPERIMENTAL STUDY OF THE BEARING CAPACITY OF INTERNAL|EXTERNAL FLANGE JOINTS SUBJECTED TO PRESSURE AND BENDING LOADINGS WITH VARIOUS ECCENTRICITIES

Structure Design of Magnetic Fluid Static Seal at Large Diameter Flange

A Study on the Sealing Performance of Metallic C-rings in Reactor Pressure Vessel

Finite-element Modelling of a Novel Flanging Process on a Cylinder with a Large Diameter–thickness Ratio

Sealing Performance of Adaptive Contacting Mechanical Seal

Numerical Analysis of Deformation of a Non-Contacting Gas Lubricated Seal

A drawing - flaring process of metal bushing ring without welding seam for plate heat exchanger

Design and experimental study on full-metal sealing structure of mandrel-type casing hanger

Semi-analytical Fluid-solid Coupling Model for Hydrostatic Mechanical Seals

Research on Radial Gap of Double-cone Structure in High Pressure Vessel

An Assessment Method of Sealing Performance and Stress Intensity Factors at Crack Tip of Subsea Connector Metal Sealing Rings