Abstract:Summary Metal–to–metal seals are used in connections of casing and tubing in oil and gas wells. This paper describes the mechanisms of sealing metal–to–metal seals as investigated using an experimental setup and a stochastic numerical sealing model. Experiments were conducted for a variety of thread compounds and applied pin/box surface coatings. The results were used to validate a stochastic numerical sealing model for sealability. The model couples a contact–mechanics model with a flow model and takes into account the influence of all the surface–topography features by introducing the concept of seal permeability. Once validated, the model was used together with the experimental results to better understand the sealing mechanisms of metal–to–metal seals. The sealing configuration is a face seal with an 80–mm roundoff radius on one face pressing against a flat on the other face. The face–seal specimens were manufactured from P110 tubing to ensure material properties that are representative for casing or tubing. The test setup used is designed for investigating only the metal–to–metal seal of the connection. The setup can perform rotary sliding under constant load to simulate surface changes during makeup and subsequently perform a leakage test. The sealing limit is determined by applying 700–bar fluid pressure and then gradually reducing the normal force until leakage is observed. The data are subsequently used to validate the previously published stochastic numerical sealing model. The results indicate a strong dependence on the type of thread compound used for the onset of leakage. The thread compound affects the amount of wear and thus changes the surface topography of the interacting surfaces. It is shown that the stochastic numerical sealing model is capable of predicting the onset of leakage within the experimental accuracy. The model shows further that certain surface topographical features improve the sealing performance. In particular, a surface manufactured by turning on a lathe that is in contact with, for instance, a smooth shot–blasted surface topography leads to highly localized contact areas, which in turn yield the best sealing performance.

Design and experimental study on full-metal sealing structure of mandrel-type casing hanger

Failure analysis on rubber sealing structure of mandrel hanger and improvement in extreme environments

Investigation on sealing gap between ring gear and case in internal gear machines

A model for reliability assessment of sealing performance of the C-shaped metal sealing ring at the outlet of the subsea tubing hanger

Research on Thread Seal Failure Mechanism of Casing Hanger in Shale Gas Wells and Prevention Measures

Failure analysis of wellhead casing and optimization of slip hanger in ultra deep wells

Structural Design and Sealing Performance Analysis of a Nanofluidic Self-Heating Unsealing Rubber Cylinder

Structural Analysis and Experimental Study on the Spherical Seal of a Subsea Connector Based on a Non-Standard O-Ring Seal

Sealing Failure Analysis on V-Shaped Sealing Rings of an Inserted Sealing Tool Used for Multistage Fracturing Processes

Circumferential Sealing Structure of a Subsea Oil and Gas Pipeline Repair Clamp

Optimization of thin-walled sealing structure based on mechanical simulation

Laboratory study on casing deformation during multistage horizontal well fracturing in shale gas development and strain based casing design

Analysis on the Mechanical and Sealing Properties of Metallic C Ring

Sealing Characteristics Analysis of New Subsea Wellhead Sealing Device

Study on the sealing performance of 105MPa conical core BOP in the fully sealed state

Reliability Analysis of Dynamic Sealing Performance in the Radial Hydraulic Drilling Technique

On the Sealability of Metal-to-Metal Seals With Application to Premium Casing and Tubing Connections

Structure Design of Magnetic Fluid Static Seal at Large Diameter Flange

Finite element analysis and structural optimization of V-shaped seal ring based on ANSYS Workbench

A special thread design for failure prevention of expandable casing