Abstract:Tubesheet-flanged joint is usually used in some situations for its detachability, such as some small scale heat exchangers. This type of structure is convenient for maintenance. But leakage will become a major failure mode for flanged joint, especially for heat exchangers with multiple passes. Temperature gradient of different passes may cause non-axisymmetric thermal loading, stress and deformation distribution. In this paper, a detailed three dimensional finite element model of a tubesheet-flanged joint of an oil-water heat exchanger is established with a flexible graphite metallic spiral wound gasket. This kind of gasket has a good compression resilience performance. The compression-unloading curve of gasket under different temperatures are used. The stress and temperature distribution of the joint and gaskets are simulated under preload condition, pressure condition and operation condition. The seating performance are evaluated using gasket compression stress and flange stiffness criteria. The results show that the gasket compression stress distributions under preload and pressure condition are similar. Under operation condition, the gasket compression stress in local area decreases significantly and the gasket compression stress distribution along the circumferential direction becomes non-uniform because of different pass temperature. The Taylor-water method, typically used for flange design, provides a design bolt load for sizing the bolt and flange, does not provide an explicit calculation for the assembly bolt load. At some locations the compression stress is much smaller than minimum seating stress using Taylor-water method to determine bolt preload. However, under preload of half bolt yield strength recommended by ASME PCC-1, all assessment parameters are within the allowable limits.

Sealing Evaluation of Tubesheet-Flanged Joint under Internal Pressure and Non-Axisymmetry Thermal Loading

Design Guidelines for Fluid-Elastic Instability of Tube Bundles Subjected to Two-Phase Cross Flow

EXPERIMENTAL STUDY OF THE BEARING CAPACITY OF INTERNAL|EXTERNAL FLANGE JOINTS SUBJECTED TO PRESSURE AND BENDING LOADINGS WITH VARIOUS ECCENTRICITIES

Modeling Hydraulically Expanded Tube-To-Tubesheet Joint Based on General Stress-Strain Curves of Tube and Tubesheet Materials

Behavior of bolted joints with metal-to-metal contact type gaskets under bolting-up and loading conditions

Simulation of Leakage Behavior on Bolted Flanged Connections in Elevated Temperature Service

Study on Mechanical Behavior of Expanding Tube-to Tubesheet and Joint Performance for Steam Generator of Nuclear Power

Comparative Study of Flange-To-Seal Contact Couplings with Bolt Relaxation under Creep Condition

Finite ElementAnalysis of Sealing Performance and Stress Intensity of the Flange

Analysis of Fin-Tube Joints in A Compact Heat Exchanger

Analytical Evaluation of Elastic Interaction in Bolted Flange Joints

ANALYTICAL MODELLING OF ELASTIC INTERACTION IN BOLTED FLANGE GASKETED JOINTS

Study on tightening characteristics of flareless pipe joint assembly process

Digital Simulation for Seal Process of Double-cone Ring in Large-sized Ammonia Converter

A Generalized Thermal Deviation Factor to Evaluate the Comprehensive Stress of Tubes under Non-Uniform Heating

Time-dependent leakage rate prediction method for bolted flange connection based on equivalent stress-temperature

Effect of Tube Arrangement on the Welding of the Tube-to-Tubesheet Joint of Shell-and-Tube Heat Exchangers Using the Finite Element Method

Safety Assessment Method of Flanged Joints at Elevated Temperature

A drawing - flaring process of metal bushing ring without welding seam for plate heat exchanger

Numerical and Experimental Study of Elastic Interaction in Bolted Flange Joints

Effect of Operating Temperature on the Performance of Expansion Joints Between Tube and Tube Plate