Abstract:Tubesheet-flanged joint is usually used in some situations for its detachability, such as some small scale heat exchangers. This type of structure is convenient for maintenance. But leakage will become a major failure mode for flanged joint, especially for heat exchangers with multiple passes. Temperature gradient of different passes may cause non-axisymmetric thermal loading, stress and deformation distribution. In this paper, a detailed three dimensional finite element model of a tubesheet-flanged joint of an oil-water heat exchanger is established with a flexible graphite metallic spiral wound gasket. This kind of gasket has a good compression resilience performance. The compression-unloading curve of gasket under different temperatures are used. The stress and temperature distribution of the joint and gaskets are simulated under preload condition, pressure condition and operation condition. The seating performance are evaluated using gasket compression stress and flange stiffness criteria. The results show that the gasket compression stress distributions under preload and pressure condition are similar. Under operation condition, the gasket compression stress in local area decreases significantly and the gasket compression stress distribution along the circumferential direction becomes non-uniform because of different pass temperature. The Taylor-water method, typically used for flange design, provides a design bolt load for sizing the bolt and flange, does not provide an explicit calculation for the assembly bolt load. At some locations the compression stress is much smaller than minimum seating stress using Taylor-water method to determine bolt preload. However, under preload of half bolt yield strength recommended by ASME PCC-1, all assessment parameters are within the allowable limits.

Design and Application of Spiral Wound Gasket Sealing for Big Opening Flange for High Temperature and Pressure Vessel

Sealing Evaluation of Tubesheet-Flanged Joint under Internal Pressure and Non-Axisymmetry Thermal Loading

Structure Design of Magnetic Fluid Static Seal at Large Diameter Flange

Design and Experimental Study on the Controllable High-Speed Spiral Groove Face Seals

Optimum Design of Spiral Grooved Mechanical Seal Based on Thermo-Hydrodynamics

Advances of Research on Bolted Flange Joints at Elevated Temperature

Theoretical and experimental approach for the characteristics of water-lubricated, high-speed double spiral-groove face seals

Numerical Simulation and Characteristics Analysis of the Turbine Shaft End Spiral Groove Mechanical Seal

Design method and research of high temperature gas floating ring seal with slightly variable gap

Thermoelastohydrodynamic Behavior of Gas Spiral Groove Face Seals Operating at High Pressure and Speed

Calculation of Structural and Circulation Parameters of Spiral-wound LNG Heat Exchanger

A Theoretical and Experimental Study on Characteristics of Water-Lubricated Double Spiral–Grooved Seals

Practical Sealing for Common Gasket Materials and Construction Types

Research and Development of a Rubber O-Ring Sealing Device for High Pressure Vessels

Theoretical Analyses and Field Applications of Gas-Film Lubricated Mechanical Face Seals with Herringbone Spiral Grooves

Experimental Study of Static Sealing of Large Flanges with Magnetic Fluid

Safety Assessment Method of Flanged Joints at Elevated Temperature

Research on Radial Gap of Double-cone Structure in High Pressure Vessel

An Improved Design of Spiral Groove Mechanical Seal

Effect of two-phase flow lubrication on sealing performance of spiral groove mechanical seal under high speed and low temperature conditions

Optimization Design of Main Parameters for Double Spiral Grooves Face Seal