Abstract:Reciprocating seals are essential elements for hydraulic cylinders. The status of the contact area between the seal and the counterpart directly determines the sealing performance. An optical test rig for the O-ring seal was constructed in this study to investigate the tribological characteristics among the contacting zone, where the cylinder was changed to be transparent and a microscope is employed to observe and record the sealing status. A numerical method coupling finite element analysis (FEA) and the mixed lubrication procedure is implemented for the theoretical analysis. A comparison between the simulation and the experiment for the sealing width, friction force, and leakage was conducted. During the reciprocating motion, it was found that the oil film thickness adhering onto the cylinder's inner wall was not even along the axial direction and that the leakage oil would be accumulated at the stroke-end position because of the seal's scraping effect. The topographic indicators for the contact mechanisms are discussed, and the results demonstrated that the implementation of the mean peak width (Rsm) for the asperity radius could obtain more reasonable results. The performance of the O-ring seal at different velocities was theoretically and experimentally investigated. With an increase in velocity, the leakage rate increased and the friction force decreased. The simulation results are consistent with the experimental results both in the overall trend and in the order of magnitude.

Experimental Study on Dynamic Sealing Performance under High Pressure and High Speed

Research and Development of A Test System for the Dynamic Performance Testing of Pneumatic Solenoid Valves

Sealing Performance Analysis of Deep-Sea Sediment Sampler

Analytical and Experimental Method of Thermal Load Estimation for Seals in Transmission of Vehicle

High-speed Abrasion Experimental Research of an Abradable Seal Rubber

High-Temperature And High-Speed Abadable Tester For Abradability Test Of Seal Coatings

Experimental Research and Finite Element Analysis of Seals in the Pressure Compensator

Investigation Into The Performance Of The Vl Seal Based On The 3d Model

Investigation into the Reciprocating Sealing Performance Based on an Optical Test Method

Investigation of Static and Dynamic Seal Performances of a Rubber O-Ring

Dynamic failure analysis of static seals under pressure fluctuation in an ultrahigh-pressure water piston pump

Experimental Investigations and Field Applications of Oil-Film-Lubricated Mechanical Face Seals with Spiral Grooves

Analysis and Experimental Study on Friction and Wear Characteristics of Super High-Speed Mechanical Seal

Experiment and Simulation on the Ferrofluid Boundary Deformation and Fluctuation Characters of a High-Speed Rotary Seal

Study on working mechanism and performance of deep groove seal at high temperature and high speed in mixed lubrication

Theoretical and Experimental Analysis for Leakage Rate and Dynamic Characteristics of Herringbone-Grooved Liquid Seals

Experimental Study of Reciprocating Sealing Performance of Nitrile Rubber O-ring

Sealing Performance Evaluation and Structural Optimization for Reducing Leakage Failures of Lip Seal Considering High-Speed Rotation Frictional Heat

Reliability Evaluation of a Dynamic-Pressure Mechanical Seal Based on Liquid Film Vaporization Phase Transition

Dynamic Response Analysis to Seal Chamber Pressure Perturbation of a New Double Spiral Groove Face Seal

Design and Experimental Study on the Controllable High-Speed Spiral Groove Face Seals