Abstract:During petroleum drilling, the reciprocating motion in the seal device leads to piston and sleeve wear, which may cause leakage of the sealing medium. Selecting appropriate materials for the piston and sleeve, along with surface modifications, can effectively prolong the seal service life of the seal. The friction and wear properties of piston and sleeve pairs of different materials in a metal sealing device were simulated by the laboratory "pin-on-block" reciprocating friction test. Pins made of 45# steel, 35CrMo, and 20Cr13 were used to simulate piston bulges, while 35CrMo samples were used to simulate sleeves. Additionally, the influence of DLC (diamond-like carbon) coating and QPQ (Quench–Polish–Quench) nitriding on the wear resistance of the materials was studied. Based on this, the friction and wear properties, along with the wear mechanism of different material pairs, were analyzed. The results show that the friction coefficient curves of the three piston base materials and the 35CrMo sleeve are similar, and the friction coefficient of 45# steel is lower than that of 35CrMo and 20Cr13 at the initial stage. The DLC surface coating exhibited the best anti-wear performance, with the lowest friction coefficient, minimal wear, and the most stable friction coefficient. Surface QPQ nitriding treatment can also improve the wear resistance of the base material. However, due to the oxide formed during nitriding being prone to flaking, the friction coefficient fluctuates significantly at the initial stage of testing, and its anti-wear performance was inferior to that of the DLC coating. This study on material pairing and surface modification provides theoretical support for material selection and surface modification design of pistons and sleeves in oil drilling sealing devices.

Analysis and Experimental Study on Friction and Wear Characteristics of Super High-Speed Mechanical Seal

High-speed Abrasion Experimental Research of an Abradable Seal Rubber

Experimental Study on Dynamic Sealing Performance under High Pressure and High Speed

The Wear of Seal Fins During High-Speed Rub Between Labyrinth Seal Fins and Honeycomb Stators at Different Incursion Rates.

Tribological Properties of Seals in Integrated Transmission of Vehicle

Investigation of High-Speed Abrasion Behavior of an Abradable Seal Rubber in Aero-Engine Fan Application

High-Temperature And High-Speed Abadable Tester For Abradability Test Of Seal Coatings

Analysis on dynamic experimental system of lubrication film properties of friction pairs in axial piston pump

Study on Frictional Performance of Mechanical Seal Spare Material Used for Nuclear Coolant Pump

Analysis of Friction and Wear Properties of Friction Ring Materials for Friction Rings under Mixed Lubrication

Influence of diamond-like carbon coatings and micro-texturing on friction and wear of seal interfaces: Experiment and simulation study

On Frictional Performance of Sintering Materials Used by Mechanical Seals in Water

Study on the Friction Behavior and Abnormal Conditions of Non-contact Mechanical Seal Based on Acoustic Emission

Study on Friction and Wear Performance of Sliding Metal Seal Materials Under Reciprocating Motion

Study on the thermal-stress coupling simulation and surface friction of mechanical seal for water pump

Simulation and Experiment Research on Abrasive Wear of the Ship Mechanical Seal

Study on working mechanism and performance of deep groove seal at high temperature and high speed in mixed lubrication

Friction and Wear Behaviors of Brush Seal under High Temperature

Evaluation on frictional performance of three different oil-lubricated impregnated graphite seal rings for aircraft integrated drive generators

Study on the Wear Performance of V-combined Tandem Seals

The Effect of Wear on the Performance of a Rotary Lip Seal