Abstract:Finger seal is a type of compliant seal configuration that has superior sealing performance compared with conventional labyrinth seals and brush seals. However, complex working conditions lead to leakage, thermal gradient and deformation, which can be more serious for a contacting finger seal due to frictional heating. In this paper, a leakage and thermal performance analysis method coupled with porous media and a real structure model was developed to numerically simulate the leakage, heat transfer and thermal deformation characteristics of a contacting finger seal. The method innovatively established a porous media fluid dynamics and heat transfer model and modified the frictional heating model by introducing the concept of a friction work conversion ratio. Then, the thermal deformation of the fingers was calculated on the basis of pressure and temperature results by using the thermal-stress module of ANSYS Workbench. The results show that the leakage analysis porous media model has good calculation accuracy and most of the fluid leaks through the finger foot, while the pressure drops mainly in this field. The highest finger temperature occurs at the downstream side of the contact surface between the finger foot and the rotor. The largest thermal deformation of each laminate occurs at the finger foot toe and increases slightly along the flow direction. Additionally, the largest relative circumferential thermal deformation can reduce the gap between the fingers by approximately 5%, which is beneficial for reducing leakage. It is suggested to increase the seal inner diameter at the finger foot toe but decrease it at the finger foot heel during the design process to decrease wear and leakage.

Study on the thermal-stress coupling simulation and surface friction of mechanical seal for water pump

Analytical and Experimental Method of Thermal Load Estimation for Seals in Transmission of Vehicle

The Wear of Seal Fins During High-Speed Rub Between Labyrinth Seal Fins and Honeycomb Stators at Different Incursion Rates.

Tribological Properties of Seals in Integrated Transmission of Vehicle

Fluid-solid coupling analysis for hydrostatic supporting slipper pair of axial piston pump for seawater desalination

Analysis of Friction and Wear Properties of Friction Ring Materials for Friction Rings under Mixed Lubrication

Coupling Analysis of Frictional Heat of Fluid Film and Thermal Deformation of Mechanical Seal End Faces

Frictional Heat Transfer Regularity of the Fluid Film in Mechanical Seals

Three-Dimensional Coupling Analysis of Flow and Thermal Performance of A Mechanical Seal

Thermo-mechanical coupling analysis of the end faces for a mechanical seal under dry friction

Analysis of friction vibration characteristics of the end face of a T-slot sealing ring under thermal deformation

Leakage, heat transfer and thermal deformation analysis method for contacting finger seals based on coupled porous media and real structure models

Analysis and Experimental Study on Friction and Wear Characteristics of Super High-Speed Mechanical Seal

On Frictional Performance of Sintering Materials Used by Mechanical Seals in Water

Experimental and numerical stady on temperature field of mechanical seal

Long-term sealing performance evaluation and service life prediction of O-rings under thermal-mechanical coupling conditions

Simulation and experimentation on the contact width and pressure distribution of lip seals

Sealing Performance of Adaptive Contacting Mechanical Seal

Multi-Physical Field, Coupled, Mixed Lubrication Analysis of Hydraulic Reciprocating Vacuum Lip Seal

Semi-analytical Fluid-solid Coupling Model for Hydrostatic Mechanical Seals

Study on Frictional Performance of Mechanical Seal Spare Material Used for Nuclear Coolant Pump