Abstract:Finger seal is a type of compliant seal configuration that has superior sealing performance compared with conventional labyrinth seals and brush seals. However, complex working conditions lead to leakage, thermal gradient and deformation, which can be more serious for a contacting finger seal due to frictional heating. In this paper, a leakage and thermal performance analysis method coupled with porous media and a real structure model was developed to numerically simulate the leakage, heat transfer and thermal deformation characteristics of a contacting finger seal. The method innovatively established a porous media fluid dynamics and heat transfer model and modified the frictional heating model by introducing the concept of a friction work conversion ratio. Then, the thermal deformation of the fingers was calculated on the basis of pressure and temperature results by using the thermal-stress module of ANSYS Workbench. The results show that the leakage analysis porous media model has good calculation accuracy and most of the fluid leaks through the finger foot, while the pressure drops mainly in this field. The highest finger temperature occurs at the downstream side of the contact surface between the finger foot and the rotor. The largest thermal deformation of each laminate occurs at the finger foot toe and increases slightly along the flow direction. Additionally, the largest relative circumferential thermal deformation can reduce the gap between the fingers by approximately 5%, which is beneficial for reducing leakage. It is suggested to increase the seal inner diameter at the finger foot toe but decrease it at the finger foot heel during the design process to decrease wear and leakage.

Coupling Analysis of Frictional Heat of Fluid Film and Thermal Deformation of Mechanical Seal End Faces

Analytical and Experimental Method of Thermal Load Estimation for Seals in Transmission of Vehicle

Frictional Heat Transfer Regularity of the Fluid Film in Mechanical Seals

Coupling Analysis of Fluid Film and Thermal Deformation of Sealing Members in Spiral Groove Mechanical Seal

Investigation on sealing gap between ring gear and case in internal gear machines

Three-Dimensional Coupling Analysis of Flow and Thermal Performance of A Mechanical Seal

Thermo-mechanical coupling analysis of the end faces for a mechanical seal under dry friction

Study on the thermal-stress coupling simulation and surface friction of mechanical seal for water pump

Semi-analytical Fluid-solid Coupling Model for Hydrostatic Mechanical Seals

Control of Leakage Rate in Spiral Groove Mechanical Seal

Optimum Design of Flat End Face Mechanical Seal Based on Coupling Analysis

Theoretical Analysis on Fluid-Structure Coupling of Hydrostatic Mechanical Seal

Numerical Analysis of Heat Transfer Coefficient in Mechanical Face Seals

Leakage, heat transfer and thermal deformation analysis method for contacting finger seals based on coupled porous media and real structure models

Numerical Analysis of the Traction Effect on Reciprocating Seals in the Hydraulic Actuator

An improved mixed lubrication model for revealing the mechanism of high speed and frictional heat on sealing performance

Analysis of the coupling mechanism of the dynamic response and mechanical-thermal deformation in mechanical seals

Analysis of Friction and Wear Properties of Friction Ring Materials for Friction Rings under Mixed Lubrication

Analysis of Thermoelastic Contact of Gas-Lubricated Rough Sealing Faces

Friction and Temperature Reduction in a Mechanical Face Seal by a Surface Texturing: Comparison between TEHD Simulations and Experiments

Analysis of friction vibration characteristics of the end face of a T-slot sealing ring under thermal deformation