Abstract:The force equilibrium and moment equilibrium play a significant role on the sealing performance of gas split floating ring seals. A small deflection angle may generate seriously wear on sealing surface and cause seal failure. Therefore, the thermo-hydrodynamic lubrication analysis of gas split floating ring seal with Rayleigh grooves is investigated considering the deflection angle and frictional heat of surface contact, which is beneficial to grasp the hydrodynamic characteristics and rules under high-temperature and high-speed conditions. Pressure and temperature distributions of sealing rings are numerically calculated for the cases with different deflection angle, rational speed, seal pressure and ambient temperature. Then, the hydrodynamic effect and sealing performance are analyzed. The obtained results show that, the surface Rayleigh step grooves do not present obvious hydrodynamic effect when split seal ring has no deflection. While, a significant hydrodynamic effect can be obtained when the split seal ring presents a deflection angle about dozens of micro radians. Here, a 10% increase of opening force is achieved when the deflection angle reaches 80 μrad in the case of speed 30,000 r/min and seal pressure 0.2 MPa. Moreover, the hydrodynamic effect becomes obvious with increasing deflection angle as well as rotational speed. Meanwhile, the growth of rotational speed results in an obvious increase of film temperature. The increase of ambient temperature has a significant influence on the decrease of leakage rate. When the ambient temperature increases from 340 K to 540 K, the leakage rate reduces exceeding 50%, however, it does not present obvious effect on the opening force. The proposed model has the potential to provide the theoretical basis and design guidance for surface grooves of gas split floating ring seal in the future.

Coupling Analysis of Fluid Film and Thermal Deformation of Sealing Members in Spiral Groove Mechanical Seal

Effect of T-groove Parameters on Steady-State Characteristics of Cylindrical Gas Seal

Control of Leakage Rate in Spiral Groove Mechanical Seal

Coupling Analysis of Frictional Heat of Fluid Film and Thermal Deformation of Mechanical Seal End Faces

An Improved Design of Spiral Groove Mechanical Seal

Frictional Heat Transfer Regularity of the Fluid Film in Mechanical Seals

Optimum Design of Spiral Grooved Mechanical Seal Based on Thermo-Hydrodynamics

Investigation on sealing gap between ring gear and case in internal gear machines

Thermal Cavitation Effect on the Hydrodynamic Performance of Spiral Groove Liquid Face Seals

Analytical and Experimental Method of Thermal Load Estimation for Seals in Transmission of Vehicle

Coupled Heat Transfer Characteristics in a Spiral Groove Mechanical Seal Lubricated by Magnetic Fluid

Thermoelastohydrodynamic Behavior of Gas Spiral Groove Face Seals Operating at High Pressure and Speed

Thermo-hydrodynamic analysis of spiral groove dry gas seals

Thermo-Hydrodynamic Effect of Gas Split Floating Ring Seal with Rayleigh Step Grooves

Three-Dimensional Coupling Analysis of Flow and Thermal Performance of A Mechanical Seal

Study on working mechanism and performance of deep groove seal at high temperature and high speed in mixed lubrication

Optimum Design of Flat End Face Mechanical Seal Based on Coupling Analysis

Influence of Fluid Slip on Operation Characteristics for High-Speed Spiral Groove Seal Ring

Fluid Inertia Effect on Spiral-Grooved Mechanical Face Seals Considering Cavitation Effects

Effect of Low Temperature Fluid Viscosity on Geometry Optimization of Double Spiral Groove Mechanical Seals