Abstract:Proceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, Ahead of Print. Due to the high speed and high pressure operating conditions, wear between the finger seal and the rotor is inevitable, and this leads to an increase of leakage clearance and becomes an important factor affecting the seal life. The theory of anisotropic elasticity was employed to describe the mechanical characteristics of the seal material. An improved Archard wear model was proposed to calculate the nodal wear rate, and the local wear direction was also determined. The wear simulation model and procedure were established based on the Arbitrary Lagrangian Eulerian adaptive mesh strategy. The effects of material density, fabric orientation, pressure differential and rotor speed on the wear characteristics of finger seal and the change of leakage clearance caused by wear loss were studied. The results show that the wear first occurs at the heel area of the finger foot bottom and gradually extends to the toe area. C/C (carbon fibre reinforced carbon matrix) composite finger seal with higher material density has smaller leakage clearance and wear depth. With the increase of fabric orientation angle, the wear depth in the heel area of finger foot is smaller, and the circumferential wear area is narrower. The average wear depth of finger seal decreases with the orientation angle. When the orientation angle is 0, the seal leakage clearance is smaller. The increase of pressure differential not only aggravates the seal wear, but also expands the wear area, and also increases the average contact pressure and leakage clearance. Increasing the rotor speed make the wear depth of the heel area of finger foot gradually increase, but the wear area becomes narrower. The average contact pressure decreases and the average leakage clearance increases. This study provides a theoretical method and basis for the prediction and evaluation of the wear life and performance of C/C composite finger seal.

The Effect of Wear on the Performance of a Rotary Lip Seal

Performance Analysis of the Cylinder Gas Film Seal between Dual-Rotor Reverse Shafts Considering Lubrication and Centrifugal Expansion Effects

A Mixed Lubrication Theoretical Model and Experimental Verification of Rotary Lip Seals

Effect of Friction Coefficient on the Mixed Lubrication Model of Rotary Lip Seals

Study on the prediction of high-speed rotary lip seal wear in aero-engine based on heat-fluid-solid coupling

A Mixed Lubrication Model for Lip Seals Based on Deterministic Surface Microdeformation

A multiscale wear simulation method for rotary lip seal under mixed lubricating conditions

Structure Optimization of Lip Seals Based on a Mixed Lubrication Model

A mixed lubrication model of a rotary lip seal using flow factors

Numerical Analysis of the Traction Effect on Reciprocating Seals in the Hydraulic Actuator

Sealing Performance Evaluation and Structural Optimization for Reducing Leakage Failures of Lip Seal Considering High-Speed Rotation Frictional Heat

Simulation and experimentation on the contact width and pressure distribution of lip seals

An improved mixed lubrication model for revealing the mechanism of high speed and frictional heat on sealing performance

Multi-Physical Field, Coupled, Mixed Lubrication Analysis of Hydraulic Reciprocating Vacuum Lip Seal

Sealing performance assessments of PTFE rotary lip seals based on the elasto-hydrodynamic analysis with the modified archard wear model

Effect of Rotating Shaft Vibration on Lip Seal Performance

The effect of aging in oil on the performance of a radial lip seal

Wear modelling and sealing performance prediction of C/C composite finger seal

Analysis of Friction and Wear Properties of Friction Ring Materials for Friction Rings under Mixed Lubrication

Numerical simulation and experimental study of shaft pumping by laser structured shafts with rotary lip seals

Study on the Performance of Reciprocating Seals under the Coupling Effect of Elastohydrodynamic Lubrication and Rubber Wear