Abstract:The cylinder gas film seal between dual-rotor reverse shafts is a new method for sealing aircraft engines that has excellent developmental prospects. We propose a novel method for determining if the sealing ring is fully fluid-lubricated using the average Reynolds equation. Considering surface roughness and centrifugal expansion, we calculated the dynamic pressure, gas film force and friction power consumption with and without inlet pressure differences for each of the four rotation modes. The gas film’s dynamic pressure effects were weakest when the dual rotors rotated in a reverse direction (Mode 3), with or without differences in inlet pressure, since solid contact is most likely to occur under counter-rotation. When the dual rotors were in counter-rotation with an inlet differential pressure of 80 kPa and fixed inner and outer rotor speeds (e.g., 3000 rpm), we calculated the minimum sealing ring film thickness, leakage rate, friction power consumption and gas film force. Changes in outer rotor speed greatly influenced the minimum film thickness and the sealing ring’s performance. Meanwhile, changes in the inner rotor speed had little influence on the minimum film thickness and sealing ring’s lubrication performance. When the speed difference was fixed and the sealing ring was fully fluid-lubricated, lubrication performance changes were mainly affected by changes in centrifugal expansion caused by the outer rotor speed. Given a fixed rotor speed and under dual-rotor counter-rotation, we calculated the effects of inlet differential pressure changes on minimum gas film thickness, leakage rate, friction power consumption, gas film force and other sealing performance variables. Leakage rate and the friction power consumption increase as inlet differential pressure increases. Our results provide a theoretical reference for avoiding solid contact of the cylinder seal between dual-rotor reverse shafts.

Sealing Performance Evaluation and Structural Optimization for Reducing Leakage Failures of Lip Seal Considering High-Speed Rotation Frictional Heat

Performance Analysis of the Cylinder Gas Film Seal between Dual-Rotor Reverse Shafts Considering Lubrication and Centrifugal Expansion Effects

An improved mixed lubrication model for revealing the mechanism of high speed and frictional heat on sealing performance

Experimental Study on Dynamic Sealing Performance under High Pressure and High Speed

Investigation Into The Performance Of The Vl Seal Based On The 3d Model

Structure Optimization of Lip Seals Based on a Mixed Lubrication Model

Study on the prediction of high-speed rotary lip seal wear in aero-engine based on heat-fluid-solid coupling

Leakage, heat transfer and thermal deformation analysis method for contacting finger seals based on coupled porous media and real structure models

The Effect of Wear on the Performance of a Rotary Lip Seal

Numerical simulation study of high-speed lip seal considering eccentricity

Theoretical and experimental approach for the characteristics of water-lubricated, high-speed double spiral-groove face seals

A Mixed Lubrication Theoretical Model and Experimental Verification of Rotary Lip Seals

Multi-Physical Field, Coupled, Mixed Lubrication Analysis of Hydraulic Reciprocating Vacuum Lip Seal

A Mixed Lubrication Model for Lip Seals Based on Deterministic Surface Microdeformation

Design of an Intelligent Self-Adjusting Lip Seal Based on an SMA Spring

The Non- Linear Contact Finite Element Analysis of Seal Structure on Large Scale Cutting Tube Machine

Simulation and experimentation on the contact width and pressure distribution of lip seals

Tangential contact modeling to seal considering elastic-plastic for lubrication transition mechanism

Sealing performance and optimization design of squamous textured mechanical seal

Analysis and Optimization of Structure Parameters of Hydrostatic Mechanical Seal

Modeling and Simulation of Wear in PTFE Lip Seals