Study on the sealing performance of 105MPa conical core BOP in the fully sealed state
Faguang Jiang Nengyi He Cheng Tian Yang Chen a College of Mechanical and Electrical Engineering,Southwest Petroleum University,Chengdu,Chinab Key Laboratory of Petroleum and Natural Gas,Education Ministry of Sichuan Province,Chengdu,Chinac Sichuan Baoshi Machinery Special Vehicle Co.,Ltd.,Si Chuan,Chinad Jiangyou Electrical Machinery Branch,Sichuan Baoshi Machinery Special Vehicle Co.,Ltd.,Si Chuan,China
DOI: https://doi.org/10.1080/10916466.2024.2415522
IF: 1.695
2024-10-17
Petroleum Science and Technology
Abstract:Achieving full sealing is a technical challenge in the simulation, manufacturing, and experimentation of annular anti-spray seals. Based on Yeoh rubber constitutive model and large deformation theory, the finite element simulation model of 105 MPa annular blowout prev conical core seal was established, the stress distribution and contact pressure law of the core under different working pressures and full sealing conditions were analyzed, the full sealing state simulation of 105 MPa annular blowout prev core was realized, and the sealing performance of the core was evaluated. The results show that the conical core can meet the sealing requirements at 105 MPa. The high stress of the conical rubber core of 323 MPa appears at the joint of the inner wall of the rubber core and the back of the support bar and the joint of the upper and lower convex of the support bar. The high stress of 892 MPa appeared in the neck and back of the upper plate and the rear area of the lower plate. When the piston operating pressure is constant, with the increase of the working pressure, the overall stress of the rubber core increases, which is easy to cause the fatigue failure of the rubber core.
energy & fuels,engineering, chemical, petroleum