Experiments on match optimization of underhood cooling module

Zhentao Liu,LV Feng,Xiaoli Yu

DOI: https://doi.org/10.3785/j.issn.1008-973X. 2011.11.018

2011-01-01

Abstract:To improve the design and match of commercial vehicle cooling system,a cooling module matching method based on underhood front module test in wind tunnel was proposed.And to a commercial vehicle for the prototype,it has been verified.The underhood front module was composed of air duct parts' modle,A/C condencer,charge air cooler(CAC) and radiator in four rows.It was tested in a wind tunnel test stand according to design requirement.The design and match of cooling module and fan were finished according to the wind test result.Finally the cooling system performance was trialed by the road test.The test results showed that when the air speed is 4.0-10.0 m/s,the single radiator's pressure drop is 55%-58% of the total number,and the air duct parts' pressure drop influence is about 3%-5%.The module's heat dissipating capacity meets the system requirement at rated load and with the effective wind speed being 7.0 m/s.The cooling system,which was designed by this method,was of good performance on road.The front end cooling module testing is propitious to improve the system design precision and save energy.