Abstract:It is always a great challenge to manufacture defect-free and high-performance pure tungsten by laser additive manufacturing until now. In this work, using nanopowder as precursors, the pure tungsten green parts were successfully manufactured by indirect additive manufacturing technology, powder extrusion printing. The subsequent debinding-sintering process of the green parts has been optimized to obtain high-relative-density, fine-grain and defect-free tungsten samples. The relative density of the sample increased with the increase of sintering temperature. The microstructures of pure tungsten prepared by direct and indirect additive manufacturing techniques were studied comparatively, including laser powder bed fusion and powder extrusion printing. The formation of microcracks in pure tungsten samples is mainly due to the high residual stress provided by laser powder bed fusion and the high ductile-to-brittle transition temperature characteristics of tungsten. The sintering temperature of the pure tungsten samples with the highest compressive strength (1290 ± 10 MPa) was determined to be 2000 °C. Compared with other sintered samples, defect-free samples sintered at 2000 °C had finer grains (9.8 μm) while maintaining high relative density (99.1 ± 0.4%). The higher strength of the sintered samples at 2000 °C is related to the fine-grain strengthening and high relative density compared to samples obtained from other direct additive manufacturing technologies and sintered at other temperatures. The indirect additive manufacturing technique based on the use of nanopowder precursors developed in this work provides a new technical approach for the additive manufacturing of high-performance tungsten and/or other refractory metals.

Achieving porous tungsten with high porosity by selective dissolution of W-Fe alloy

High-pressure Preparation of Bulk Tungsten Material with Near-Full Densification and High Fracture Toughness

Mechanical Properties and Thermal Shock Performance of W-Y2O3composite Prepared by High-Energy-rate Forging

A novel dissolution-precipitation mechanism during liquid phase sintering and its strengthening effects in W-Ni-Fe alloys with low W contents

The Integrated Preparation of Porous Tungsten Gradient Materials with a Wide Porosity Range

Microstructure and mechanical properties of liquid–phase sintered W@NiFe composite powders

Fabrication and Characterization of Tungsten Heavy Alloys with High W Content by Powder Metallurgy

Simultaneous enhancements of strength and hardness for fine-grained W-NiFeCoCrMn composites

Achieving high-performance pure tungsten by additive manufacturing: Processing, microstructural evolution and mechanical properties

Eco-Friendly Material Extrusion 3D Printing for Fabricating W-Ni-Fe Lattices with Improved Compressive Resistance

Microstructure and mechanical properties of tungsten fiber reinforced tungsten composites prepared by Fe activated sintering

Fabrication of porous CoCrFeMnNi high entropy alloy using binder jetting additive manufacturing

Achieving fine-grain tungsten heavy alloys by selecting a high entropy alloy matrix with low W grain growth rate

Microstructure and mechanical properties of Wf/W composites influenced by Y2O3 coating

The effects of SiC addition on the sintering densification, phases, microstructure and mechanical properties of W

Mechanical Properties of a Novel Tungsten Fiber-Reinforced Tungsten Composite Prepared Through Powder Extrusion Printing and High-Pressure High-Temperature Sintering

The effect of Fe in the rapid thermal explosion synthesis and the high-temperature corrosion behavior of porous Co-Al-Fe intermetallic

Tungsten Strongly Inhibits Sintering of Porous Iron During High‐Temperature Redox Cycling

Bonding Tungsten, W–Cu-alloy and Copper with Amorphous Fe–W Alloy Transition

Preparation Method of Porous Tungsten

Excellent performance of W–Y2O3 composite via powder process improvement and Y2O3 refinement