Abstract:Tungsten grid thin-wall structures are extensively utilized as ray filtering parts in medical equipment and nuclear industries. In this work, tungsten grid thin-wall structures with a wall thickness of approximately 100 μm were fabricated via laser powder bed fusion (LPBF) additive manufacturing technology. Post-treatments were employed to suppress the defects generated in LPBF-printed tungsten grid thin-wall structures, and the mechanisms of the defect formation and suppression were discussed. The adhesions attached to the wall surface were effectively eliminated by employing chemical corrosion and sandblasting, resulting in improved values of top and lateral surface roughness at 6.4 μm and 1.65 μm, respectively. The thin-wall structure annealed at 1400 °C presented the highest relative density of 98.28 % and unique microstructure with its lateral surface exhibiting elongated columnar grains in thin wall areas. Micro-defects including pores and cracks were observed around grain boundaries. The micro-defects deteriorated when annealed below the recrystallization temperature of 1300 °C, whereas they were effectively suppressed when annealed at 1400 °C. Consequently, this sample group exhibited exceptional mechanical properties. The stress experienced during the initial collapse in compression testing of the thin-wall structures annealed at 1400 °C was calculated to be 100.61 MPa. Subsequently, through a nano-indentation testing, the hardness and Young's modulus were measured as 9.15 GPa and 153.41 GPa respectively in thin-wall area, while in intersection area they were measured as 9.96 GPa and 381.44 GPa. The enhancement in mechanical properties of annealed tungsten grid thin-wall structures was attributed to gas pore release, diffusion densification and reduced residual stress.

Achieving high-performance pure tungsten by additive manufacturing: Processing, microstructural evolution and mechanical properties

Microstructure, Compressive Performance and Wear Resistance of Pure Molybdenum Additively Manufactured Via Laser Powder Bed Fusion

High-pressure Preparation of Bulk Tungsten Material with Near-Full Densification and High Fracture Toughness

Selective Laser Melting of High-Performance Pure Tungsten: Parameter Design, Densification Behavior and Mechanical Properties

Simulation and Experimental Investigation on Additive Manufacturing of Highly Dense Pure Tungsten by Laser Powder Bed Fusion

High-density Tungsten Fabricated by Selective Laser Melting: Densification, Microstructure, Mechanical and Thermal Performance

Advances in Laser Powder Bed Fusion of Tungsten, Tungsten Alloys, and Tungsten-Based Composites

Defect formation mechanism and suppression strategy in additively manufactured tungsten grid thin-wall structures via laser powder bed fusion

A review of tungsten fabricated via laser powder bed fusion

Selective Laser Melting and Remelting of Pure Tungsten

Dense Pure Tungsten Fabricated by Selective Laser Melting

Development of Tungsten-Based Materials by Different Sintering Techniques

Effects of laser printing parameters on molten pool formation, microstructure evolution and mechanical properties of laser directed energy deposition of difficult-to-process tungsten heavy-alloy

Alloying Effects on the Microstructure and Properties of Laser Additively Manufactured Tungsten Materials

Cracking Mechanisms in Additively Manufactured Pure Tungsten from Printing Single Tracks, Thin Walls and Cubes

The simultaneous improvement of strength and ductility of the 93W-4.6Ni-2.4Fe prepared by additive manufacturing via optimizing sintering post-treatment

Laser Powder Bed Fusion of Pure Tungsten: Effects of Process Parameters on Morphology, Densification, Microstructure

Laser powder bed fusion of a novel nano-modified tungsten alloy with refined microstructure and enhanced strength

High compression strength pure tungsten fabricated by plasma arc additive manufacturing

Crack‐Free Tungsten Fabricated via Laser Powder Bed Fusion Additive Manufacturing

Microstructure Evolution and Mechanical Properties of Tungsten Alloy Prepared by Laser Directed Energy Deposition