Abstract:It is challenging for laser powder bed fusion (LPBF) technique to fabricate metal parts with a wall thickness below 100 μm. This work investigated the critical conditions for achieving extremely thin wall thickness in tungsten grids fabricated via LPBF. Specifically, the impact of low energy density on the printability of tungsten single tracks and grids via LPBF was comprehensively examined. A computational fluid dynamics approach was employed to develop a thermal fluid flow model for single tracks with multilayers in LPBF. The findings demonstrate that at low energy densities, single tracks exhibit four different morphologies, i.e., balling, discontinuity and winding, discontinuity but straightness, as well as continuity and straightness. The simulation model effectively elucidates the continuity of single tracks and provides insights into the governing mechanism of molten pool defects. Due to high thermal diffusion properties of tungsten, the continuity of its track relies on the connection of neighboring molten pools and is sensitive to scanning speed. The tungsten molten pools with low energy density can be categorized into shallow flows affected by surface morphology and deep flows influenced by internal voids of the powder bed. After multi-layer stacking, the track fluctuations and defects in single tracks accumulated into greater surface roughness and deteriorate thin-walled morphology. The critical conditions required for printing extremely thin walls were achieved, ensuring minimal merging of tracks between two layers by maintaining the energy density of 57 J/mm 3 . Based on these findings, an ultra-thin-walled anti-scattering tungsten grid with a wall thickness of 86 μm and a wall roughness below 3.3 μm ( Ra ) was fabricated by LPBF. This work provides valuable theoretical insights and presents a viable methodology for determining the minimum energy density threshold and wall thickness essential for LPBF processing of thin-walled components.

Dense Pure Tungsten Fabricated by Selective Laser Melting

Microstructure, Compressive Performance and Wear Resistance of Pure Molybdenum Additively Manufactured Via Laser Powder Bed Fusion

High-pressure Preparation of Bulk Tungsten Material with Near-Full Densification and High Fracture Toughness

Simulation and Experimental Investigation on Additive Manufacturing of Highly Dense Pure Tungsten by Laser Powder Bed Fusion

Fabrication of Fully Dense Tial-Based Composite Sheets with A Novel Microlaminated Microstructure

A review of tungsten fabricated via laser powder bed fusion

Fabrication of High-Density Microarchitected Tungsten via DLP 3D Printing

Achieving high-performance pure tungsten by additive manufacturing: Processing, microstructural evolution and mechanical properties

Selective laser melting fabricated tungsten with thin-walled structure: role of linear energy density on temperature evolution and manufacturing quality

Balling Phenomena in Selective Laser Melted Tungsten

Mechanical Properties of a Novel Tungsten Fiber-Reinforced Tungsten Composite Prepared Through Powder Extrusion Printing and High-Pressure High-Temperature Sintering

High compression strength pure tungsten fabricated by plasma arc additive manufacturing

Densification, microstructural evolutions of 90W-7Ni-3Fe tungsten heavy alloys during laser melting deposition process

Cracking Behavior in Additively Manufactured Pure Tungsten

Enhanced Tensile Ductility of Tungsten Microwires Via High-Density Dislocations and Reduced Grain Boundaries

Microstructure and thermal properties of unalloyed tungsten deposited by Wire + Arc Additive Manufacturing

Three-dimensional porous tungsten via DLP 3D printing from transparent ink

Microstructure and mechanical behavior of porous tungsten skeletons synthesized by selected laser melting

Molten pool behaviors and printability of tungsten anti-scattering grids with extremely thin wall thickness fabricated via laser powder bed fusion

Advances in Laser Powder Bed Fusion of Tungsten, Tungsten Alloys, and Tungsten-Based Composites

Melting and Solidifying Behavior in Single Layer Selective Laser of Pure Tungsten Powder