Abstract:To reduce the negative effects of the long-time and B2O3 phase on the traditional sintering process for B4C-based composite ceramics, nearly fully dense B4C–VB2 composite ceramics were prepared by reactive spark plasma sintering (SPS) technology at 2000 °C with B and V8C7 powders as raw materials in this paper. The effects of the degassing time during SPS on the microstructure and the mechanical properties of the final products were investigated in detail. The results revealed that the proper degassing time was beneficial for the vent of B2O3 during the sintering process, which refined the grain size, promoted densification and improved the mechanical properties of the composite ceramic. However, the redundant degassing time increased the holding time at high temperature, resulting in abnormal grain growth and mechanical performance deterioration. In the present work, the optimal degassing time was 6 min, and the final product prepared under the above conditions exhibited excellent comprehensive performance with a relative density of 99.2%, Vickers hardness of 31.2 GPa, bending strength of 654 MPa and fracture toughness of 5.7 MPa m1/2. In addition, the strengthening and toughening mechanisms of the products were mainly attributed to the residual thermal stresses and bridging structure caused by the fine B4C and VB2 grains distributed uniformly.

Densification and strengthening mechanism in spark plasma sintering of B4C–VB2 ceramics via carbide boronizing

High‐strength TiB 2 ‐B 4 C Composite Ceramics Sintered by Spark Plasma Sintering

Influence of Length-Scale on Stabilization of Boron Carbide in Al-based Metal Matrix Composites During Plasma Activated Sintering

Preparation of dense B4C ceramics by spark plasma sintering of high-purity nanoparticles

Influence of Silicon Addition on the Sintering Behavior and Mechanical Properties of Boron Carbide by SPS Process

Microstructure and mechanical behaviour of transient liquid phase spark plasma sintered B4C–SiC–TiB2 composites from a B4C–TiSi2 system

Continuum Modeling of B4C Densification During Spark Plasma Sintering

Processing and mechanical properties of B4C-SiCw ceramics densified by spark plasma sintering

Spark plasma sintering of B4C–ZrB2 and B4C–ZrB2–SiC ceramics

Densification and grain growth kinetics of boron carbide powder during ultrahigh temperature spark plasma sintering

Microstructure and mechanical properties of spark plasma sintered SiC ceramics aided by B4C

The Effect of CNTs on the Spark Plasma Sintering Densification Behavior and Mechanical Properties of B4C-Si Powders

Influence of CNTs on the Sintering Behavior and Mechanical Properties of Boron Carbide by SPS Process

B4C-based hard and tough ceramics densified via spark plasma sintering using a novel Mg2Si sintering aid

Multi-stage spark plasma sintering to study the densification mechanisms of boron carbide

Effects of Boron Content on the Microstructure and Properties of BxC-TiB2 (x=4.5, 6.5 or 8.5) Ceramic Composites by the Reactive Spark Plasma Sintering

Enhancement mechanical properties of in-situ preparated B4C-based composites with small amount of (Ti3SiC2+Si)

Toughening mechanism of B4C/TiB2 ceramic materials by in situ reaction via spark plasma sintering

Densification and mechanical properties of boron carbide prepared via spark plasma sintering with cubic boron nitride as an additive

Reaction mechanism and friction behavior of an in-situ Ti/B4C composite synthesized by spark plasma sintering

Influence of Y2O3 contents on sintering and mechanical properties of B4C-Al2O3 multiphase ceramic composites