Abstract:To reduce the negative effects of the long-time and B2O3 phase on the traditional sintering process for B4C-based composite ceramics, nearly fully dense B4C–VB2 composite ceramics were prepared by reactive spark plasma sintering (SPS) technology at 2000 °C with B and V8C7 powders as raw materials in this paper. The effects of the degassing time during SPS on the microstructure and the mechanical properties of the final products were investigated in detail. The results revealed that the proper degassing time was beneficial for the vent of B2O3 during the sintering process, which refined the grain size, promoted densification and improved the mechanical properties of the composite ceramic. However, the redundant degassing time increased the holding time at high temperature, resulting in abnormal grain growth and mechanical performance deterioration. In the present work, the optimal degassing time was 6 min, and the final product prepared under the above conditions exhibited excellent comprehensive performance with a relative density of 99.2%, Vickers hardness of 31.2 GPa, bending strength of 654 MPa and fracture toughness of 5.7 MPa m1/2. In addition, the strengthening and toughening mechanisms of the products were mainly attributed to the residual thermal stresses and bridging structure caused by the fine B4C and VB2 grains distributed uniformly.

B4C-based hard and tough ceramics densified via spark plasma sintering using a novel Mg2Si sintering aid

Microstructure and mechanical properties of spark plasma sintered SiC ceramics aided by B4C

Processing and mechanical properties of B4C-SiCw ceramics densified by spark plasma sintering

Spark plasma sintering of B4C–ZrB2 and B4C–ZrB2–SiC ceramics

Enhanced Mechanical Properties of Nanocrystalline B4C–SiC Composites by In-Situ High Pressure Reactive Sintering

Microstructure and mechanical behaviour of transient liquid phase spark plasma sintered B4C–SiC–TiB2 composites from a B4C–TiSi2 system

The Effect of CNTs on the Spark Plasma Sintering Densification Behavior and Mechanical Properties of B4C-Si Powders

Mechanical properties and pre-oxidation behavior of spark plasma sintered B4C ceramics using (Ti3SiC2+CeO2/La2O3) as sintering aid

High-performance B4C matrix composites fabricated from the B4C–Si–CeO2 system via reactive hot pressing

Microstructure and mechanical properties of B4C based ceramics with Fe3Al as sintering aid by spark plasma sintering

Densification and strengthening mechanism in spark plasma sintering of B4C–VB2 ceramics via carbide boronizing

Enhancement mechanical properties of in-situ preparated B4C-based composites with small amount of (Ti3SiC2+Si)

B4C-SiC skeleton reinforced graphite composites with excellent mechanical properties

B 4 C-SiC Skeleton Reinforced Graphite Composites with Excellent Mechanical Properties

Preparation of dense B4C ceramics by spark plasma sintering of high-purity nanoparticles

Effects of silicon addition on the microstructure and properties of B 4 C–SiC composite prepared with polycarbosilane-coated B 4 C powder

Pressureless Sintering of ZrB2–SiC Ceramics: the Effect of B4C Content

High‐strength TiB 2 ‐B 4 C Composite Ceramics Sintered by Spark Plasma Sintering

Microstructures and mechanical properties of B4C‐SiC and B4C‐SiC‐TiB2 ceramic composites fabricated by hot pressing

The role of Mg2Si additive in sintering silicon carbide

Influence of Silicon Addition on the Sintering Behavior and Mechanical Properties of Boron Carbide by SPS Process