Abstract:A series of hydrocracking catalysts based on mesoporous molecular sieves of MCM-41 and SBA-15 with different silica to alumina ratios was prepared. Nickel and molybdenum were used as active metals to impregnate the extrudates prepared by using molecular sieves. The catalysts were characterized for physical and chemical properties and evaluated for the hydrocraking of desulfurised vacuum gas oil. The conversion of DS-VGO was lower as compared to that of the catalyst based on USY zeolite. However, the gas yield was lower in case of mesoporous materials based catalysts. Introduction Zeolites are widely used as catalysts in petroleum refining and for the production of petrochemicals and fine chemicals. Recently, the breakthrough discovery of the M41S family mesoporous materials [1,2] exemplified by the MCM-41 bearing hexagonal-close-packed channels. Despite the excellent structural properties, the hydrothermal stability of MCM-41 and MCM-41-like mesoporous materials was reported as lower than their counter part zeolites. Recently, a new kind of mesoporous silica, SBA-15, has been synthesized with poly (alkylene oxide) triblock copolymers such as poly (ethylene oxide)-poly (propylene oxide)poly (ethylene oxide) (PEO-PPO-PEO) [3]. Beside its uniform and large pore size channels (4.6-30 nm), SBA-15 possesses thick walls (3.1-6.4 nm). Therefore, it has much higher hydrothermal stability than MCM-41 [3]. Owing to their extremely large surface area (generally exceeding 1000 mg) and ultra large pore size these mesoporous materials have attracted great practical and academic interest as acid-catalyzed reactions of large molecules such as hydroprocessing of residual oil [4-5]. In this study, the preparation of MCM-41 and SBA-15 with Si/Al 10, 20 and hydrocracking catalysts based on these mesoporous materials along with USY zeolite are presented. Commercial USY zeolite used in this study also has mesopores in it. Nickel and molybdenum are impregnated as active metals. Mesoporous materials and hydrocracking catalysts prepared were characterized by XRD, surface are, pore volume, pore-size distribution, particle size measurement, and acidity measurement by FTIR and ammonia TPD. The side crushing strength of the extrudates with alumina binder was also measured by crushing strength tester. The catalysts were evaluated for hydrocracking of desulfurized vacuum gas oil (DS-VGO). The hydrocracking activity was measured by GC-SIMDIST method and sulfur and nitrogen contents of the product were measured by elemental analyzer.

Preparation of Y-type molecular sieve based on bentonite and study of its performance in hydrocatalytic cracking of shale oil

Nanometer β Zeolite Made from Mesoporous Zeolite and Its Hydrocracking Performance

Continuous Synthesis of Mesoporous Y Zeolites from Normal Inorganic Aluminosilicates and Their High Adsorption Capacity for Dibenzothiophene (DBT) and 4,6-Dimethyldibenzothiophene (4,6-DMDBT)

Synthesis and Catalytic Evaluation of Mesoporous Molecular Sieve Supported Hydrocracking Catalysts

Synthesis of mesoporous high-silica zeolite Y and their catalytic cracking performance

Hydrocracking of Heavy Oil Using Zeolites Y/Al-SBA-15 Composites As Catalyst Supports

Synthesis of Nanoporous Flower-like Y-SAPO-11 Composite Molecular Sieves for Hydrocracking of n -Hexadecane

A defect-based strategy for the preparation of mesoporous zeolite Y for high-performance catalytic cracking

Effect of Zeolite-Y Modification on Crude-Oil Direct Hydrocracking

Catalytic and deactivated behavior of SAPO-34/ZSM-5 composite molecular sieve synthesized by in-situ two-step method

Optimization of Conditions for Preparation of ZSM-5@silicalite-1 Core–shell Catalysts Via Hydrothermal Synthesis

Preparation of hierarchical β and Y zeolite-containing mesoporous silica–aluminas and their properties for catalytic cracking of n-dodecane

Effects of post treatment of HZSM-5 zeolites on catalytic cracking of butene

Hydrocracking catalyst containing small crystal grain Y-shaped molecular sieve and preparation method thereof

Application of Oil Shale Molecular Sieve Catalyst: a Review

Synthesis and Post-synthesis Modification of Zeolite Y for Improved Methanol Adsorption and Coke Formation Resistance

Synthesis of Small Crystal Size Y Zeolite Catalysts with High Hydrocracking Performance on n -Hexadecane

Hierarchical submicrosized Y zeolites prepared by sequential desilication-dealumination post-synthesis modification and their catalytic performance in vacuum gas oil hydrocracking.

Catalytic Cracking of n-Dodecane to Chemicals: Effect of Variable-Morphological ZSM-5 Zeolites Synthesized Using Various Silica Sources

Advances in Research of the Stability of Molecular Sieve Catalysts for Olefin Cracking

Binder Selection to Modify Hydrocarbon Cracking Properties of Zeolite-Containing Composites.