Abstract:A series of hydrocracking catalysts based on mesoporous molecular sieves of MCM-41 and SBA-15 with different silica to alumina ratios was prepared. Nickel and molybdenum were used as active metals to impregnate the extrudates prepared by using molecular sieves. The catalysts were characterized for physical and chemical properties and evaluated for the hydrocraking of desulfurised vacuum gas oil. The conversion of DS-VGO was lower as compared to that of the catalyst based on USY zeolite. However, the gas yield was lower in case of mesoporous materials based catalysts. Introduction Zeolites are widely used as catalysts in petroleum refining and for the production of petrochemicals and fine chemicals. Recently, the breakthrough discovery of the M41S family mesoporous materials [1,2] exemplified by the MCM-41 bearing hexagonal-close-packed channels. Despite the excellent structural properties, the hydrothermal stability of MCM-41 and MCM-41-like mesoporous materials was reported as lower than their counter part zeolites. Recently, a new kind of mesoporous silica, SBA-15, has been synthesized with poly (alkylene oxide) triblock copolymers such as poly (ethylene oxide)-poly (propylene oxide)poly (ethylene oxide) (PEO-PPO-PEO) [3]. Beside its uniform and large pore size channels (4.6-30 nm), SBA-15 possesses thick walls (3.1-6.4 nm). Therefore, it has much higher hydrothermal stability than MCM-41 [3]. Owing to their extremely large surface area (generally exceeding 1000 mg) and ultra large pore size these mesoporous materials have attracted great practical and academic interest as acid-catalyzed reactions of large molecules such as hydroprocessing of residual oil [4-5]. In this study, the preparation of MCM-41 and SBA-15 with Si/Al 10, 20 and hydrocracking catalysts based on these mesoporous materials along with USY zeolite are presented. Commercial USY zeolite used in this study also has mesopores in it. Nickel and molybdenum are impregnated as active metals. Mesoporous materials and hydrocracking catalysts prepared were characterized by XRD, surface are, pore volume, pore-size distribution, particle size measurement, and acidity measurement by FTIR and ammonia TPD. The side crushing strength of the extrudates with alumina binder was also measured by crushing strength tester. The catalysts were evaluated for hydrocracking of desulfurized vacuum gas oil (DS-VGO). The hydrocracking activity was measured by GC-SIMDIST method and sulfur and nitrogen contents of the product were measured by elemental analyzer.

Application of Oil Shale Molecular Sieve Catalyst: a Review

Study on the Pyrolysis of Cellulose for Bio-Oil with Mesoporous Molecular Sieve Catalysts.

Recent Progress on In Situ Catalytic Conversion Catalysts for Oil Shale

Enhancing oil shale pyrolysis using metal-doped carbon quantum dot catalysts: A comprehensive behavioral, kinetic, and mechanistic analysis

Advances in Research of the Stability of Molecular Sieve Catalysts for Olefin Cracking

[Influence of ZSM-5(38)/Al-MCM-41 Composite Molecular Sieve Catalysts on Pyrolysis of Cellulose].

Theoretical Investigation on the Catalytic Effect and Mechanism of Pure and Cu−Doped SBA−15 Molecular Sieves on the Decomposition of Dimethyl Sulfoxide

Preparation of Y-type molecular sieve based on bentonite and study of its performance in hydrocatalytic cracking of shale oil

Development review and the prospect of oil shale in-situ catalysis conversion technology

Mesoporous Zeolites As Efficient Catalysts for Oil Refining and Natural Gas Conversion

Catalytic Effects on Combustion Behavior of Oil Shale: Thermal Conversion, Kinetic, Mechanism Analyses

Synthesis and Catalytic Evaluation of Mesoporous Molecular Sieve Supported Hydrocracking Catalysts

Research on the Application of Catalytic Materials in Biomass Pyrolysis

Application of Molecular Sieves in Transformations of Biomass and Biomass-Derived Feedstocks

Investigation on the Catalytic Cracking Mechanism of CuO on Dimethyl Sulfoxide (C2H6OS) and Surface Modification Effects: Insights from Density Functional Theory Calculations

Catalytic Conversion of Oil Shale over Fe or Ni Catalysts under Sub-Critical Water

A Review on Catalytic Fast Co-Pyrolysis Using Analytical Py-GC/MS

Hydrodeoxygenation of lignin-derived bio-oil using molecular sieves supported metal catalysts: A critical review

Aromatic Hydrocarbon Production and Catalyst Regeneration in Pyrolysis of Oily Sludge Using ZSM-5 Zeolites As Catalysts

Kinetic modeling of oil shale upgrading at sub- and supercritical water conditions using Ni- and Fe-based oil-soluble catalysts