Abstract:A series of hydrocracking catalysts based on mesoporous molecular sieves of MCM-41 and SBA-15 with different silica to alumina ratios was prepared. Nickel and molybdenum were used as active metals to impregnate the extrudates prepared by using molecular sieves. The catalysts were characterized for physical and chemical properties and evaluated for the hydrocraking of desulfurised vacuum gas oil. The conversion of DS-VGO was lower as compared to that of the catalyst based on USY zeolite. However, the gas yield was lower in case of mesoporous materials based catalysts. Introduction Zeolites are widely used as catalysts in petroleum refining and for the production of petrochemicals and fine chemicals. Recently, the breakthrough discovery of the M41S family mesoporous materials [1,2] exemplified by the MCM-41 bearing hexagonal-close-packed channels. Despite the excellent structural properties, the hydrothermal stability of MCM-41 and MCM-41-like mesoporous materials was reported as lower than their counter part zeolites. Recently, a new kind of mesoporous silica, SBA-15, has been synthesized with poly (alkylene oxide) triblock copolymers such as poly (ethylene oxide)-poly (propylene oxide)poly (ethylene oxide) (PEO-PPO-PEO) [3]. Beside its uniform and large pore size channels (4.6-30 nm), SBA-15 possesses thick walls (3.1-6.4 nm). Therefore, it has much higher hydrothermal stability than MCM-41 [3]. Owing to their extremely large surface area (generally exceeding 1000 mg) and ultra large pore size these mesoporous materials have attracted great practical and academic interest as acid-catalyzed reactions of large molecules such as hydroprocessing of residual oil [4-5]. In this study, the preparation of MCM-41 and SBA-15 with Si/Al 10, 20 and hydrocracking catalysts based on these mesoporous materials along with USY zeolite are presented. Commercial USY zeolite used in this study also has mesopores in it. Nickel and molybdenum are impregnated as active metals. Mesoporous materials and hydrocracking catalysts prepared were characterized by XRD, surface are, pore volume, pore-size distribution, particle size measurement, and acidity measurement by FTIR and ammonia TPD. The side crushing strength of the extrudates with alumina binder was also measured by crushing strength tester. The catalysts were evaluated for hydrocracking of desulfurized vacuum gas oil (DS-VGO). The hydrocracking activity was measured by GC-SIMDIST method and sulfur and nitrogen contents of the product were measured by elemental analyzer.

Advances in Research of the Stability of Molecular Sieve Catalysts for Olefin Cracking

Effects of post treatment of HZSM-5 zeolites on catalytic cracking of butene

Strategies To Enhance The Catalytic Performance Of Zsm-5 Zeolite In Hydrocarbon Cracking: A Review

Engineering Zeolites for Catalytic Cracking to Light Olefins

Effect of Hierarchical ZSM-5 Zeolite Crystal Size on Diffusion and Catalytic Performance of N-Heptane Cracking

Catalytic cracking of C4 alkenes to propene and ethene: Influences of zeolites pore structures and Si/Al2 ratios

Understanding the enhancement of catalytic performance for olefin cracking: Hydrothermally stable acids in P/HZSM-5

Hydrocracking of Heavy Oil Using Zeolites Y/Al-SBA-15 Composites As Catalyst Supports

Advances in Catalysts for Maximizing Ethylene and Propylene by Catalytic Cracking Process

Catalysts in the Catalytic Cracking of Hydrocarbons to Produce Light Olefins

Synergetic Regulation of the Microstructure and Acidity of HZSM-5/MCM-41 for Efficient Catalytic Cracking of n-Decane

MOLECULAR SIEVE CATALYSTS FOR REMOVING OLEFINS FROM AROMATIC HYDROCARBONS BY ALKYLATION REACTION

Full-crystalline Hierarchical Monolithic ZSM-5 Zeolites As Superiorly Active and Long-Lived Practical Catalysts in Methanol-to-hydrocarbons Reaction

Catalytic Cracking Reactions Of C-4-Olefin Over Zeolites H-Zsm-5, H-Mordenite And H-Sapo-34

Comparative Research on the Supercritical Catalytic Cracking of n-Dodecane and Kerosene Using Nanosheet MFI Zeolite

Zeolite domination in coordination between metal and acid sites on an industrial catalyst for tetralin hydrocracking

Facile Synthesis of Nanosheet-Stacked Hierarchical ZSM-5 Zeolite for Efficient Catalytic Cracking of n-Octane to Produce Light Olefins

Application of Oil Shale Molecular Sieve Catalyst: a Review

Synthesis of ZSM-48 zeolites and their catalytic performance in C4-olefin cracking reactions

Synthesis and Catalytic Evaluation of Mesoporous Molecular Sieve Supported Hydrocracking Catalysts

Study on Production of Propylene from C4 Olefins by Catalytic Cracking