Abstract:This paper investigates the influence of bore pressure, combined with the nonlinear behaviour of the polymer material, on the creep behaviour of the polymer barrier layer inside an unbonded flexible pipe. Creep behaviour in the barrier layer may result in its reduction in thickness and is therefore an important design consideration in ensuring the structural integrity of this layer. It is meaningful to study the variation in creep behaviour in an unbonded flexible pipe under different bore pressures and temperatures, especially in high pressure pipelines for deep or ultra-deep sea applications. Creep behaviour in polymer material is complex, as it is governed by a number of variables such as the stress/strain state, temperature, and pressure for example. It is generally time-dependent and often associated with larger strains or states of deformation. Owing to the complexity of polymer material creep, an implicit time hardening creep model, based on the Maxwell viscoelastic model, has been selected to represent the creep behaviour in polymer materials and implemented into the Gap Span model, which is an in-house ANSYS based finite element model. The coefficients of this creep model were initially calibrated according to standard creep tests performed on polymer materials. The study presented in this paper focuses on the influence of bore pressure and high temperature on the creep behaviour of the polymer barrier layer. Comparisons between the simulation results of the calibrated Gap Span creep model and the corresponding small-scale creep tests demonstrate that these model predictions are overly conservative for the polymer material of the barrier layer inside an unbonded flexible pipe. Comparisons between the experimental test results and the finite element modelling results show good correlation.

Influence of wall thickness on the creep rupture performance of polyethylene pipe

Investigation On Creep-Rupture Failure Time Of Hdpe Pipe Under Hydrostatic Pressure

Viscoelastic and Damage Model of Polyethylene Pipe Material for Slow Crack Growth Analysis

Creep rapture of plastic pipes: Effect of eccentricity, residual stress, and circumferential orientation

Prediction of Ductile Rupture Failure Life of HDPE Pipe

Investigation of Interfacial Debonding Between Steel Wire and Adhesive Resin

Short-Term Mechanical Analysis of Polyethylene Pipe Reinforced by Winding Steel Wires Using Steel Wire Spiral Structural Finite Element Model

Study on Viscoelastic Behavior During Slow Crack Growth of Medium Density Polyethylene Pipes

Plastic Failure Analysis of Defective Pipes with Creep Damage under Multi-Loading Systems

The performance and causes of failure of polyethylene pipes subjected to constant and fluctuating internal pressure loadings

Influence of Bore Pressure on the Creep Behaviour of Polymer Barrier Layer Inside an Unbonded Flexible Pipe

Theoretical Assessment of Burst Failure of Internally Pressurized Defect-Free Pipelines with Plastic Anisotropy

Creep Behaviors Calculated by Varying Material Constants Obtained from Different Stress Regions for a Closed-End P91 Pipe

Lifetime predictions for virgin and recycled high-density polyethylene under creep conditions

Plastic Limit Analysis of Piping with Local Wall-Thinning under Elevated Temperature

Strain Rate-Dependent Hyperbolic Constitutive Model for Tensile Behavior of PE100 Pipe Material

Analysis of the Creep Mechanism of Low-Alloy Steel in Terms of Plastic Deformation

Investigation of Creep Behavior of HDPE Pipe Butt Fusion Welded Joints Using a Stepped Isostress Method

CCG of PE100 and Life Prediction of PE Pipe With Axial Semi-Elliptical Crack

Investigation of Tensile Creep Behavior for High-Density Polyethylene (HDPE) via Experiments and Mathematical Model

Nonlinear Time-Dependent Mechanical Behavior of Medium-Density Polyethylene Pipe Material