Abstract:High-density polyethylene (HDPE) materials have many applications in the municipal solid waste (MSW) landfills. HDPE gravity drainage pipes are commonly utilized in MSW landfills because of the polymer's resistance to harsh chemical conditions. When landfill wastes are freshly filled, the weight acting on the leachate collection pipe increases. The temperature of the leachate collection pipe increases as a result of the heat produced by the decomposition of organic components after waste filling. In this paper, the effects of sequentially applying pressure and elevating temperature on the deformation characteristics (such as deformations and strains) of HDPE pipes are investigated. Measurements of pipe deformations and circumferential strains from model experiments in which 110 mm HDPE pipes were backfilled with sand and subjected to 300 kPa of maximum vertical pressure at temperatures of 20, 60 and 80 °C showed the following results: (1) a classification of pipe behavior relative to the surrounding soil stiffness is advantageous for HDPE pipe design; (2) when temperature increases to 60 °C and 80 °C, the strain distribution around the pipe changes from V-shaped to U-shaped, and the pipe deformation profile changes from elliptical to rectangular; (3) when temperature increases from 20 °C to 60 °C, the vertical and horizontal pipe deflections increase by a factor of 1.08~1.19; (4) when temperature increases from 60 °C to 80 °C, the vertical and horizontal pipe deflections increase by a factor of 1.15~1.31; and (5) the existing analytical method that considers two extreme interfaces can capture the deformations measured in the model test well. In addition, preliminary recommendations for the design of leachate collection pipes are provided based on the analysis of differences in pipe profile versus temperature.

Nonlinear Time-Dependent Mechanical Behavior of Medium-Density Polyethylene Pipe Material

Viscoelastic and Damage Model of Polyethylene Pipe Material for Slow Crack Growth Analysis

Short-Term Mechanical Analysis of Polyethylene Pipe Reinforced by Winding Steel Wires Using Steel Wire Spiral Structural Finite Element Model

Investigation On Creep-Rupture Failure Time Of Hdpe Pipe Under Hydrostatic Pressure

Strain Rate-Dependent Hyperbolic Constitutive Model for Tensile Behavior of PE100 Pipe Material

Prediction of Ductile Rupture Failure Life of HDPE Pipe

Experimental and Numerical Investigation on the Seismic Behavior of above Ground High Density Polyethylene Pipe in Nuclear Power Plant

Study On Constitutive Modeling For Large Deformation Behavior Of Polyethylene Considering Strain Rate Effect

The performance and causes of failure of polyethylene pipes subjected to constant and fluctuating internal pressure loadings

Numerical Simulation of Strength Failure of Buried Polyethylene Pipe under Foundation Settlement

Feasibility of Nonlinear Ultrasonic Method to Characterize the Aging Degree of Polyethylene Pipes

Investigating the Deformation Characteristics of Buried High-Density Polyethylene Pipes: Considering the Effect of Sequentially Applying Pressure and Elevating Temperature

Fatigue crack growth and slow crack growth of HDPE pipes under internal pressure and flat plate compression

CCG of PE100 and Life Prediction of PE Pipe With Axial Semi-Elliptical Crack

Investigation of Tensile Creep Behavior for High-Density Polyethylene (HDPE) via Experiments and Mathematical Model

Quantitative Assessment of Damage in Buried Polyethylene Pipe Subjected to Land Subsidence

Mechanism of Slow Crack Growth in Polyethylene: A Finite Element Approach

A Comprehensive Review of Polyethylene Pipes: Failure Mechanisms, Performance Models, Inspection Methods, and Repair Solutions

Finite Element Analysis of Buried Polyethylene Pipe Subjected to Seismic Landslide

Mechanical Behavior of Polyethylene Pipes under Strike-Slip Fault Movements

Rate-dependent Constitutive Model of Poly(ethylene Terephthalate) for Dynamic Analysis