Abstract:Abstract High density polyethylene (HDPE) is widely used in city water and gas piping system and even in nuclear engineering for its excellent properties in flexibility, impact resistance, aging and corrosion resistance, reliable connection, long service life. It is generally believed that the typical failure mode of PE pipe under long-term static pressure load is the slow crack growth (SCG) caused by creep crack initiation (CCI) and creep crack growth (CCG), which is a kind of quasi-brittle failure. Scratching often occurs during PE pipe installation due to the drag of pipe without any protection, which would leave axial cracks as the initial defect. This would harm the long term performance of pressurized HDPE pipe. In the present work, the creep crack kinetics was experimentally determined in term of C* integral, and then CCG behavior of PE pipe with axial semi-elliptical crack was discussed. With the help of a CARE electronic universal testing machine and DIC displacement measuring system, creep tests are performed with smooth bar specimen of PE100 pipe parent material. And the stationary creep law parameters were determined. The crack opening displacement (COD) rates were determined by creep cracking test with cracked round bar specimen. With the help of compliance calibration tests, the COD curves were changed into crack propagation curves and the creep crack kinetics was eventually determined in term of C* integral. By assuming an semi-elliptical crack front with nearly the same C* integral, the creep crack propagation was predicted with the determined crack kinetics. And the allowable initial crack size was also determined for the PE pipe discussed. Compared with that determined in terms of SIF, current study yields much margin for the allowable initial crack.

Prediction of Ductile Rupture Failure Life of HDPE Pipe

Investigation On Creep-Rupture Failure Time Of Hdpe Pipe Under Hydrostatic Pressure

Probabilistic model to predict longitudinal fracture failure of buried pvc pipes

Viscoelastic and Damage Model of Polyethylene Pipe Material for Slow Crack Growth Analysis

Failure Prediction and Reliability Analysis of Buried Grey Cast Iron Water Mains Considering Corrosion

Plastic Collapse Analysis of Thin-Walled Pipes Based on Unified Yield Criterion

Failure Prediction Model and Influence Parameter Analysis of Buried Cast Iron Water Mains

Short-Term Mechanical Analysis of Polyethylene Pipe Reinforced by Winding Steel Wires Using Steel Wire Spiral Structural Finite Element Model

Experimental and Numerical Investigation on the Seismic Behavior of above Ground High Density Polyethylene Pipe in Nuclear Power Plant

CCG of PE100 and Life Prediction of PE Pipe With Axial Semi-Elliptical Crack

Theoretical Assessment of Burst Failure of Internally Pressurized Defect-Free Pipelines with Plastic Anisotropy

Analytical prediction of failure pressure for pipeline with long corrosion defect

Mechanical model and probability analysis of buried pipelines failure under uniform corrosion

Ductile burst behavior of high pressure X100 steel pipe considering hydrogen damage

Fatigue crack growth and slow crack growth of HDPE pipes under internal pressure and flat plate compression

Burst Pressure of Pipelines with Plastic Anisotropy under Combined Internal and External Pressures

Prediction On Short-Term Burst Pressure Of Plastic Pipe Reinforced By Cross-Winding Steel Wires

Quantitative Assessment of Damage in Buried Polyethylene Pipe Subjected to Land Subsidence

Behavior of Flexible Pipe Subjected to Internal Pressure

Analysis on the Long-Term Hydrostatic Strength of Kevlar Fibre Reinforced Flexible Pipe

The performance and causes of failure of polyethylene pipes subjected to constant and fluctuating internal pressure loadings