Abstract:Thermoelectric materials with high average power factor and thermoelectric figure of merit (ZT) has been a sought-after goal. Here, we report new n-type thermoelectric system CuxPbSe0.99Te0.01 (x = 0.0025, 0.004, and 0.005) exhibiting record-high average ZT ∼ 1.3 over 400–773 K ever reported for n-type polycrystalline materials including the state-of-the-art PbTe. We concurrently alloy Te to the PbSe lattice and introduce excess Cu to its interstitial voids. Their resulting strong attraction facilitates charge transfer from Cu atoms to the crystal matrix significantly. It follows the increased carrier concentration without damaging its mobility and the consequently improved electrical conductivity. This interaction also increases effective mass of electron in the conduction band according to DFT calculations, thereby raising the magnitude of Seebeck coefficient without diminishing electrical conductivity. Resultantly, Cu0.005PbSe0.99Te0.01 attains an exceptionally high average power factor of ∼27 μW cm–1 K–2 from 400 to 773 K with a maximum of ∼30 μW cm–1 K–2 at 300 K, the highest among all n- and p-type PbSe-based materials. Its ∼23 μW cm–1 K–2 at 773 K is even higher than ∼21 μW cm–1 K–2 of the state-of-the-art n-type PbTe. Interstitial Cu atoms induce the formation of coherent nanostructures. They are highly mobile, displacing Pb atoms from the ideal octahedral center and severely distorting the local microstructure. This significantly depresses lattice thermal conductivity to ∼0.2 Wm–1 K–1 at 773 K below the theoretical lower bound. The multiple effects of the dual incorporation of Cu and Te synergistically boosts a ZT of Cu0.005PbSe0.99Te0.01 to ∼1.7 at 773 K.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/jacs.0c07712?goto=supporting-info">https://pubs.acs.org/doi/10.1021/jacs.0c07712</a>.Details in theoretical calculations, additional APT results, and thermoelectric properties (<a class="ext-link" href="/doi/suppl/10.1021/jacs.0c07712/suppl_file/ja0c07712_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Contrasting Cu Roles Lead to High Ranged Thermoelectric Performance of PbS

Enhanced thermoelectric performance of n -type PbTe bulk materials fabricated by semisolid powder processing

Boosting thermoelectric performance of n-type PbS through synergistically integrating In resonant level and Cu dynamic doping

Superior thermoelectric performance in PbTe-PbS pseudo-binary: extremely low thermal conductivity and modulated carrier concentration

Lattice expansion enables interstitial doping to achieve a high average ZT in n‐type PbS

Realizing Ultrahigh Thermoelectric Performance in n‐Type PbSe Through Lattice Planification and Introducing Liquid‐Like Cu Ions

Enhancement of low-temperature thermoelectric performance via Pb doping in Cu3SbSe4

Achieving higher thermoelectric performance of n-type PbTe by adjusting band structure and enhanced phonons scattering

Band Engineering Through Pb‐Doping of Nanocrystal Building Blocks to Enhance Thermoelectric Performance in Cu3SbSe4

Thermoelectric enhancement for n-type PbS via synergistic effect of Ti doping and Cu2S compositing

PbS–Pb–Cu x S Composites for Thermoelectric Application

Exceptionally High Average Power Factor and Thermoelectric Figure of Merit in n-type PbSe by the Dual Incorporation of Cu and Te

High Performance Thermoelectrics from Earth-Abundant Materials: Enhanced Figure of Merit in PbS by Second Phase Nanostructures.

Defect Chemistry Engineering Promotes the Dopability of Cu for an Extraordinary Thermoelectric Performance of Hole-Doped PbSe with Resonant States

Multiscale structure and band configuration tuning to achieve high thermoelectric properties in n-type PbS bulks

Realizing high-ranged thermoelectric performance in PbSnS2 crystals

High Performance Thermoelectrics from Earth-Abundant Materials: Enhanced Figure of Merit in Pbs Through Nanostructuring Grain Size

Contrasting Thermoelectric Transport Properties of n-Type PbS Induced by Adding Ni and Zn

Enhancement of thermoelectric performance of Cu 1.98 Se by Pb doping

Contrasting Thermoelectric Transport Behaviors of p -Type PbS Caused by Doping Alkali Metals (Li and Na)

Enhanced thermoelectric performance of hot-press Bi-doped n-type polycrystalline PbS