Abstract:This study presents a colloidal synthesis method to produce thermoelectric Cu3SbSe4 nanocrystals with high yield. Pb doping is employed to increase carrier concentration and effective mass, confirmed by experimental studies and theoretical calculations. Additionally, lattice distortions and other intriguing nanostructures are found to significantly reduce thermal conductivity. Consequently, the thermoelectric figure of merit zT is greatly enhanced. Developing cost‐effective and high‐performance thermoelectric (TE) materials to assemble efficient TE devices presents a multitude of challenges and opportunities. Cu3SbSe4 is a promising p‐type TE material based on relatively earth abundant elements. However, the challenge lies in its poor electrical conductivity. Herein, an efficient and scalable solution‐based approach is developed to synthesize high‐quality Cu3SbSe4 nanocrystals doped with Pb at the Sb site. After ligand displacement and annealing treatments, the dried powders are consolidated into dense pellets, and their TE properties are investigated. Pb doping effectively increases the charge carrier concentration, resulting in a significant increase in electrical conductivity, while the Seebeck coefficients remain consistently high. The calculated band structure shows that Pb doping induces band convergence, thereby increasing the effective mass. Furthermore, the large ionic radius of Pb2+ results in the generation of additional point and plane defects and interphases, dramatically enhancing phonon scattering, which significantly decreases the lattice thermal conductivity at high temperatures. Overall, a maximum figure of merit (zTmax) ≈ 0.85 at 653 K is obtained in Cu3Sb0.97Pb0.03Se4. This represents a 1.6‐fold increase compared to the undoped sample and exceeds most doped Cu3SbSe4‐based materials produced by solid‐state, demonstrating advantages of versatility and cost‐effectiveness using a solution‐based technology.

Thermoelectric enhancement for n-type PbS via synergistic effect of Ti doping and Cu2S compositing

Achieving higher thermoelectric performance of n-type PbTe by adjusting band structure and enhanced phonons scattering

Achieving Higher Thermoelectric Performance of N-Type PbTe by Adjusting the Band Structure and Enhanced Phonon Scattering

Boosting thermoelectric performance of n-type PbS through synergistically integrating In resonant level and Cu dynamic doping

Synergistically Enhancing Thermoelectric Performance of N‐type PbTe with Indium Doping and Sulfur Alloying

High Performance of N-Type (Pbs)(1-X-y)(pbse)(x)(pbte)(y) Thermoelectric Materials

Promoting SnTe As an Eco‐Friendly Solution for P‐pbte Thermoelectric Via Band Convergence and Interstitial Defects

Enhancement of Thermoelectric Performance for N-Type PbS Via Synergy of CuSbS2 Alloying and Cl Doping

Synergistically Optimizing Charge and Phonon Transport Properties in N-Type PbTe Via Introducing Ternary Compound AgSb(Se, Te)2

Investigations on Distinct Thermoelectric Transport Behaviors of Cu in N-Type PbS

Realizing high-ranged thermoelectric performance in PbSnS2 crystals

An Approach of Enhancing Thermoelectric Performance for P-Type PbS: Decreasing Electronic Thermal Conductivity

Subtle Roles of Sb and S in Regulating the Thermoelectric Properties of N‐Type PbTe to High Performance

Band Engineering Through Pb‐Doping of Nanocrystal Building Blocks to Enhance Thermoelectric Performance in Cu3SbSe4

Lattice expansion enables interstitial doping to achieve a high average ZT in n‐type PbS

Synergistically optimizing carrier and phonon transport properties in n-type PbTe through I doping and SnSe alloying

Realizing thermoelectric cooling and power generation in N-type PbS0.6Se0.4 via lattice plainification and interstitial doping

Multiscale structure and band configuration tuning to achieve high thermoelectric properties in n-type PbS bulks

Enhancing Thermoelectric Performance of N-Type PbTe Through Separately Optimizing Phonon and Charge Transport Properties

High-performance in n-type PbTe-based thermoelectric materials achieved by synergistically dynamic doping and energy filtering

Enhanced Thermoelectric Performance of N‐Type PbSe Through Semi‐Coherent Nanostructure by AgCuTe Alloying