Abstract:This study presents a colloidal synthesis method to produce thermoelectric Cu3SbSe4 nanocrystals with high yield. Pb doping is employed to increase carrier concentration and effective mass, confirmed by experimental studies and theoretical calculations. Additionally, lattice distortions and other intriguing nanostructures are found to significantly reduce thermal conductivity. Consequently, the thermoelectric figure of merit zT is greatly enhanced. Developing cost‐effective and high‐performance thermoelectric (TE) materials to assemble efficient TE devices presents a multitude of challenges and opportunities. Cu3SbSe4 is a promising p‐type TE material based on relatively earth abundant elements. However, the challenge lies in its poor electrical conductivity. Herein, an efficient and scalable solution‐based approach is developed to synthesize high‐quality Cu3SbSe4 nanocrystals doped with Pb at the Sb site. After ligand displacement and annealing treatments, the dried powders are consolidated into dense pellets, and their TE properties are investigated. Pb doping effectively increases the charge carrier concentration, resulting in a significant increase in electrical conductivity, while the Seebeck coefficients remain consistently high. The calculated band structure shows that Pb doping induces band convergence, thereby increasing the effective mass. Furthermore, the large ionic radius of Pb2+ results in the generation of additional point and plane defects and interphases, dramatically enhancing phonon scattering, which significantly decreases the lattice thermal conductivity at high temperatures. Overall, a maximum figure of merit (zTmax) ≈ 0.85 at 653 K is obtained in Cu3Sb0.97Pb0.03Se4. This represents a 1.6‐fold increase compared to the undoped sample and exceeds most doped Cu3SbSe4‐based materials produced by solid‐state, demonstrating advantages of versatility and cost‐effectiveness using a solution‐based technology.

Enhanced thermoelectric performance of hot-press Bi-doped n-type polycrystalline PbS

Enhanced thermoelectric performance of n -type PbTe bulk materials fabricated by semisolid powder processing

High Thermoelectric Efficiency Of N-Type Pbs

Enhanced thermoelectric properties of Pb1-xBixS prepared with hydrothermal synthesis and microwave sintering

High Performance Thermoelectrics from Earth-Abundant Materials: Enhanced Figure of Merit in PbS by Second Phase Nanostructures.

Boosting thermoelectric performance of n-type PbS through synergistically integrating In resonant level and Cu dynamic doping

Na/Bi-co-doping and Heterogeneous Interfaces Leading to Enhanced Thermoelectric Performance of P-Type Mg3Sb2-based Zintls

Enhanced thermoelectric performance of PbTe based materials by Bi doping and introducing MgO nanoparticles

N-Type Bi-doped PbTe Nanocubes with Enhanced Thermoelectric Performance

Boosting Thermoelectric Performance of PbBi2Te4 Via Reduced Carrier Scattering and Intensified Phonon Scattering.

Thermoelectric Performance Of Nanostructured In/Pb Codoped Snte With Band Convergence And Resonant Level Prepared Via A Green And Facile Hydrothermal Method

High Performance of N-Type (Pbs)(1-X-y)(pbse)(x)(pbte)(y) Thermoelectric Materials

Thermoelectrics with Earth Abundant Elements: High Performance P-Type PbS Nanostructured with SrS and CaS

Band Engineering Through Pb‐Doping of Nanocrystal Building Blocks to Enhance Thermoelectric Performance in Cu3SbSe4

Multiscale structure and band configuration tuning to achieve high thermoelectric properties in n-type PbS bulks

Realizing thermoelectric cooling and power generation in N-type PbS0.6Se0.4 via lattice plainification and interstitial doping

Enhancing Thermoelectric Performance of N-Type PbSe Through Forming Solid Solution with PbTe and PbS

Broadening the optimum thermoelectric power generation range of p-type sintered Bi0.4Sb1.6Te3 by suppressing bipolar effect

Tunable Electrical Conductivity and Simultaneously Enhanced Thermoelectric and Mechanical Properties in n‐type Bi2Te3

Achieving higher thermoelectric performance of n-type PbTe by adjusting band structure and enhanced phonons scattering

Achieving Higher Thermoelectric Performance of N-Type PbTe by Adjusting the Band Structure and Enhanced Phonon Scattering