The influence of emitter-base junction design on collector saturation current, ideality factor, Early voltage, and device switching speed of Si/SiGe HBT's

A. Gruhle

DOI: https://doi.org/10.1109/16.277379

IF: 3.1

1994-01-01

IEEE Transactions on Electron Devices

Abstract:In advanced Si/SiGe HBT's the base is doped much higher than emitter and collector. Base outdiffusion becomes a problem because of the formation of parasitic barriers that degrade device performance. The simulations and experiments of this paper show that a strong correlation exists between (a) the drop of the collector saturation current, (b) an increase of its ideality factor and (c) a rise of the switching time due to an additional emitter delay which can no longer be neglected. Curves of these three parameters as a function of Si/SiGe heterointerface position and outdiffusion at the base-emitter interface have been calculated and indicate that only a few nm shift may cause severe device degradation. An important result is that the collector current ideality factor or the inverse Early voltage is a very sensitive indicator for the quality of the emitter-base interface. Application of these results have yielded experimental SiGe HBT's with transit frequencies above 60 GHz.<>

engineering, electrical & electronic,physics, applied