Abstract:This study investigates the adhesion properties of polycarbonate (PC) and liquid silicone rubbers (LSR) through surface activation using ultraviolet C (UVC) radiation. While self-adhesive LSRs adhere easily to certain thermoplastic composites such as polybutylene terephthalate (PBT) and polyamides (PAs), bonding to PC typically requires surface treatment due to the lack of compatible functional groups. Previous methods like plasma or flame treatment have been effective, but the use of UVC radiation for surface activation remains unexplored. Through experiments, it was found that UVC surface activation, particularly with ozone-generating lamps, significantly enhances the peel strength between PC and self-adhesive LSRs. The study evaluates the impact of different irradiation times and lamp configurations on peel resistance, surface energy, and composite stability. Results show that UVC/ozone (wavelengths 254 nm and 185 nm) activation increases peel resistance, with distinct differences observed between LSR types. Additionally, the study examines the stability of UVC activation over time and under various storage conditions, highlighting its effectiveness for up to 36 months at room temperature. Furthermore, the relationship between surface energy and peel strength is analyzed, finding that UVC/ozone activation increases surface energy but does not consistently correlate with improved adhesion. The study concludes with a comparison of UVC/ozone activation to alternative surface treatment methods, emphasizing its advantages such as cost-effectiveness and stability while considering limitations regarding substrate compatibility and occupational safety aspects. Overall, UVC/ozone surface activation presents a promising approach for enhancing adhesion in PC–LSR composite systems and holds potential for applications across various industries.

UV Activation Treatment for Hydrophobic Wafer Bonding

Stabilizing the Wettability of Initiated Chemical Vapor Deposited (icvd) Polydivinylbenzene Thin Films by Thermal Annealing

Mechanisms for low-temperature direct bonding of Si/Si and quartz/quartz via VUV/O3 activation

Effect of Combined Hydrophilic Activation on Interface Characteristics of Si/Si Wafer Direct Bonding

Research on Silicon-Glass Thermal Bonding with SiO2 Film Assist

Research on Silicon-Glass Direct Bonding at Room Temperature

Low Temperature Hydrophilic SiC Wafer Level Direct Bonding for Ultrahigh-Voltage Device Applications

Preoxidation UV Treatment of Silicon Wafers

High-Pressure Water-Vapor Annealing for Enhancement of A-Si:H Film Passivation of Silicon Surface

Time‐Dependent Surface Properties and Wafer Bonding of O 2 ‐ Plasma ‐ Treated Silicon (100) Surfaces

Low-Temperature III–V Direct Wafer Bonding Surface Preparation Using a UV-Sulfur Process

Low Temperature Direct InP/SOI Wafer Bonding Based on Hydrophilic/hydrophobic Treatment

UVC Irradiation as a Surface Treatment of Polycarbonate to Generate Adhesion to Liquid Silicone Rubber in an Overmolding Process

Three Steps Method of Hydrophilicity Treatment on Silicon Wafer Direct Bonding and Bonding Interface Electrical Properties

SILICON DIRECT BONDING (SDB) WITH HYDROPHOBIC SURFACE TREATMENTS

A Model of Low‐Temperature Wafer Bonding And Its Applications

The effects of oxygen plasma and humidity on surface roughness, water contact angle and hardness of silicon, silicon dioxide and glass

Study of InP/SOI Wafer Bonding Based on Wet Surface Activation Treatment

Enhancement of the Bond Strength and Reduction of Wafer Edge Voids in Hybrid Bonding

Surface Modification of Poly(dimethylsiloxane)-fabricated Microfluidic Chip by UV Radiation

Mechanisms for room temperature direct wafer bonding