Abstract:The cyclone separator has a simple structure but cannot effectively separate respirable dust of smaller particle sizes. The cartridge filter has a high separation efficiency, but its pressure drop increases too rapidly, requiring frequent cleaning operations. To make up for these defects, a novel cartridge-filtering cyclone combining both cyclone separator and cartridge filter is presented. Its performance parameters, including pressure drop, overall separation efficiency, grading efficiency, and cleaning interval, were studied experimentally and compared with those of the common cyclone and cartridge filter. The cartridge-filtering cyclone first pre-separates the larger particles by swirling airflow, and then filters out the fine particles through the filter cartridges, thus slowing down the increasing rate of the pressure drop and forming denser dust layers attached to the surface of the filter cartridges. The experimental results show that the cartridge-filtering cyclone has a better dust removal effect. At an inlet flow rate of 50 m(3)/h, the separation efficiency of the cartridge-filtering is 99.86%, which is 15.32% and 0.05% higher than that of the common cyclone and cartridge filter, respectively. In particular, the cartridge-filtering cyclone has a preferable separation effect on fine particles, with a separation efficiency for 2.5 mu m particles of 99.11%, which is 70.80% and 0.08% higher than that of the common cyclone and cartridge filter, respectively. Compared with the cartridge filter, the cleaning interval of the cartridge-filtering cyclone is extended and the total dust emission is reduced. Over the whole experimental period, the average cleaning interval and dust emission concentration of the cartridge-filtering cyclone are 1290.05 seconds and 12.06 mg/m(3) respectively, while that of the cartridge filter are 80532 seconds and 14.59 mg/m(3), respectively. (C) 2018 Elsevier B.V. All rights reserved.

Cyclone dust collector with double ash discharge structure

Volute cyclone dust collector

Three-stage cyclone separation dust collector

High-efficiency long-life cyclone dust collector

Micro Gas Cyclone Design and Performance Evaluation to Collect Dust Particles

Study on Separation Performance of Tri-Cone Water Medium Cyclone Based on CFD

Wet-type whirlwind dust collector

Studies of a Water-Only Cyclone with a Three-Stage Cone for Fine Coal Beneficiation

Design of Anti-explosion Sufur-dust Multi Cyclone

Axial flow type cyclone dust collector

Efficient Cyclone Dust Collecting Equipment

Analysis of the Performance of a Novel Dust Collector Combining Cyclone Separator and Cartridge Filter

Dust Removal Principle and Numerical Simulation of New Type Cyclone-bag Combined Dust Collector

Improvement and Analysis on Cyclone Dust Collector

Enhancement of the classification and recovery process of fine mineral particles via a newly developed volute feed hydrocyclone

Double-Eccentric Design for the Vortex Finder of a Cyclone Separator

Analysis of Flow Field and Improved Design of Cyclone Separator with Downward Exhaust Gas

Design of Attrition Resistant Cyclone Dust Collector

Structural Design and Numerical Simulation of Inner Flow Field for Cyclone Dust Collector

Wide temperature high leakproofness dust collector of formula of controlling oneself

Dust collection polar plate based on particle trap effect, novel polarity form and efficient electrostatic dust collector