Abstract:Abstract The axial cyclone separator has simple structure, operates to reducing dust concentration in grain storehouses, and features low production cost, and convenient installation. Aiming to obtain the separation characteristics of an axial flow guide separator, the particle wall collision and the performance of multi-tubes were simulated with Fluent. The renormalization group (RNG) k − ε model was used to study the turbulent modeling and the user define function (UDF) was used to calculate the particle-wall collision. The simulation and experimental results were compared to verify the computation model. The results showed that the basic feature of the flow pattern remains stable and the separation efficiency of 800 kg/m 3 particles is higher than 2650 kg/m 3 particles when the inlet velocity increases from 2 to 5 m/s. When the inlet velocity was 5 m/s, the normal velocity restitution ratio had a significant effect on the efficiency, the separation efficiency of 167 μm particles changed from 76.74 to 97.93% and a smaller normal velocity restitution ratio had a higher the efficiency. In comparison, the efficiency remained unchanged when changing the tangential velocity restitution ratio. Furthermore, the effects of three target wall materials on the separation efficiency were investigated. And the simulated efficiency the of 296 μm particle of 2024 aluminum, 410 stainless steel and Ga1–4V titanium were 82.15, 79.52 and 77.53% respectively. Besides, effects of tube diameter on performances of cyclone separator were discussed and high intense collisions between particles and walls may occur in a small diameter of cyclone tube, causing deteriorated separation performance. Moreover, with the addition of the dust chamber, the efficiency of cyclone used in combination is slightly improved since the vortex in the exhaust pipe has been finely changed.

Structural Design and Numerical Simulation of Inner Flow Field for Cyclone Dust Collector

Micro Gas Cyclone Design and Performance Evaluation to Collect Dust Particles

Study on Separation Performance of Tri-Cone Water Medium Cyclone Based on CFD

Performance Evaluation of a New Micro Gas Cyclone Using Simulation and Experimental Studies to Capture Indoor Fine Particles

Numerical Simulation of the Effect of a Reducing Pressure Drop Stick in a Spiral Cyclone

Numerical Simulation of Three Dimensional Gas-Particle Flow in a Spiral Cyclone

Numerical simulation of the particle-wall collision strength and swirling effect on the performance of the axial flow cyclone separator

Study on the floatation mechanism and floatation performance for the floatation cyclone of natural inlet air

Influence of Cyclone Combustor Structure on the Motion Behaviors of Solid Fuel Particles

Dust Removal Principle and Numerical Simulation of New Type Cyclone-bag Combined Dust Collector

Numerical Simulating the Gas-solid Flow in Square Cyclone With a Curved Inlet

Improvement and Analysis on Cyclone Dust Collector

Simulation calculation of cyclone separation efficiency

Design of Attrition Resistant Cyclone Dust Collector

Numerical analysis of cyclone separators with unique Dipleg structures at different Dipleg-to-dustbin ratios

Experimental study on a new type of cyclone separator for fine particles

Numerical investigations on the aerodynamics and flue gas recirculation of cyclone-fired coal boiler

Numerical Simulation of Three-Dimension Flow Field in a New-Type Cyclone Separator with a Radial Inlet Structure

Numerical simulation on structure optimization of escape-pipe of cyclone separator with downward outlet

CFD Numerical Simulation of Flow Velocity Characteristics of Hydrocyclone

Numerical simulation of the complex flow field in a new recycling cyclone separator