Numerical Simulation of Three-Dimension Flow Field in a New-Type Cyclone Separator with a Radial Inlet Structure

W. Fuchen

Abstract:Different from the traditional cyclones with tangential inlet pipe, the prepared new-type cyclone with radial inlet structure has the advantages of reducing the difficulty of welding work during preparation, being suitable for high pressure operation, and having higher separation efficiency. Based on the Reynolds stress model (RSM), the gas-phase flow field in the new-type cyclone separator with radial inlet was numerically simulated, and the simulation results are in good agreement with the measured results, which shows that the RSM model can be used to well predict the gas flow in the new type cyclone separator. The results also indicate that the periodic oscillation of the vortex core exists in all axial sections of the separation space, and the inner gas flow field in the cyclone shows asymmetry which behaves that the spinning center of the gas flow deviates from the geometrical center of the cyclone. The tangential velocity profile can be described as a Rankine vortex, a combined free and forced vortex located at the position with the diameter of 0.8 dr (vortex finder diameter). The tangential velocity increases with decreasing the inlet angle and the diameter ratio between the vortex finder and the cyclone ( dr = dr/D), and the swirling flow regions also change. In addition, the tangential velocity profile in the vortex finder can be described as "U" type, and the swing frequency of the vortex core in the vortex finder is higher than that in the separation space.

Environmental Science,Physics,Engineering