Abstract:Abstract Climate change is the leading severe problem in the twenty-first century, which is associated with greenhouse gas emissions, carbon dioxide that is the foremost cause of global warming and super greenhouse effect. In this concern, to avoid hazardous problems, the steady stream of CO 2 effluents existing in the atmosphere must be transformed to beneficial products for being used as an abundant chemical feedstock. Implementing a new green strategy, which is known for the catalytic hydrogenation of CO 2 into alternative fuels and valuable chemicals, will be a long-lasting solution to alleviate CO 2 emissions. In this paper, a process simulation showing the synthesis of dimethyl ether (DME) from CO 2 hydrogenation (CO 2 produced from EL-Sewedy cement industry) is performed using Aspen HYSYS V10 to attain a complete distinctive design for all equipment for producing a capacity of 475,000 tons per year, while energy integration is performed using Energy Analyzer Simulation software. In the main model, catalytic dehydration is done in a single-pass reactor, and then separation in multi-column product separations. Other configurations were tested by developing three simulation models with different reactors, a double pipe reactor and membrane reactor were with the aim of modification for higher energy efficiency and lower operating and capital costs. Moreover, an economic and environmental study was obtained for the basic & the integrated case, which showed that the total annual/capital costs based on the “base case” are estimated to be 90 million USD without heat integration while the optimum and integrated costs are found to be 100 Million USD. Finally, process optimization and integration were obtained to reduce the utilized energy of the hot & cold utilities by 90% and 60%, respectively.

4E Evaluation and Multi-Objective Optimization of Low Concentration Flue Gas CO2 Capture and Multi-Product Conversion Process

Systematic Design and Optimization of a Membrane–Cryogenic Hybrid System for CO2 Capture

A 4E Analysis of a Novel Coupling Process of Syngas Purification and CO2 Capture, Transcritical CO2 Power and Absorption Refrigeration

Simulation Optimization of A New Ammonia-Based Carbon Capture Process Coupled with Low-Temperature Waste Heat Utilization

Simulation and Optimization of Carbon Dioxide Capture Using Water-Lean Solvent from Industrial Flue Gas

Optimization of Carbon Capture Process Using Aqueous Ammonia with Rate-Based Simulation Method

Optimization of Post Combustion CO2 Capture from a Combined-Cycle Gas Turbine Power Plant via Taguchi Design of Experiment

Modeling and Economic Analysis on Combined Capture of CO2 and SO2 in Flue Gas Using Aqueous Ammonia

Tech-economic and environmental analysis of energy-efficient shale gas and flue gas coupling system for chemicals manufacture and carbon capture storage and utilization

Energy, Exergy, Economic and Environmental (4E) Analysis of an Integrated Process Combining CO2 Capture and Storage, an Organic Rankine Cycle and an Absorption Refrigeration Cycle

Process modeling of an advanced NH₃ abatement and recycling technology in the ammonia-based CO₂ capture process

Integrated CO 2 capture and conversion into methanol units: Assessing techno-economic and environmental aspects compared to CO 2 into SNG alternative

Optimizing the CO 2 capture and removal process to recover energy and CO 2 from the flue gas of boilers and gas turbines outlet with considering the techno-economic analysis

Energy-efficient Process Intensification for Post-Combustion CO2 Capture: A Modeling Approach

Intrinsic Insight of Energy-Efficiency Optimization for CO2 Capture by Amine-Based Solvent: Effect of Mass Transfer and Solvent Regeneration

Process Simulation and Energy Consumption for CO<SUB Align="right">2 Capture with Different Flowsheets

Multistage Circulation Absorption Improvement: Simulation and Energy-Saving Evaluation of an Innovative Amine-Based CO2 Capture Process

Analysis of integrated CO 2 capture and utilization via calcium-looping in-situ dry reforming of methane and Fischer-Tropsch for synthetic fuels production

Process Simulation for Converting CO2 Emissions from the Cement Industry to Dimethyl Ether

Modelling and Process Analysis of Post-Combustion Carbon Capture with the Blend of 2-Amino-2-methyl-1-propanol and Piperazine

Process design and energy analysis on synthesis of liquid fuels in an integrated CCUS system