Abstract:Recent decades have seen a growing concern about ever-increasing green house gas (GHG) emissions and depletion of fossil fuels. Polygeneration, a multi-input multi-output energy system, provides huge opportunities to tackle these problems due to its superior performances over conventional energy systems in terms of energy conversion efficiency and GHG emissions. Many approaches have been made in process design and analysis of polygeneration energy systems, but most of them focus on using coal gasification as the only way to provide gas for downstream utilization. Coke oven gas, another gas source with huge capacity, however, has not received enough attention in polygeneration process design, and researches in this field are still rather limited. In this paper, we present a dual-gas sourced polygeneration process design which uses both gasification gas and coke oven gas and produces methanol, dimethyl ether (DME), and dimethyl carbonate (DMC) in an integrated catalysis procedure. Gasification gas and coke oven gas are converted to synthesis gas, or syngas, via a catalytic reforming procedure, where the ratio between carbon monoxide and hydrogen in the syngas is carefully adjusted according to specific requirements of downstream chemical synthesis reactions. An integrated catalysis procedure follows, where DME is synthesized from the fresh syngas first, unconverted syngas is then sent to a methanol synthesis unit to produce methanol, and part of the methanol is further converted to DMC in a DMC synthesis unit. Based on the proposed process design, an exergoeconomic analysis and an exergy cost distribution diagram are presented, from which the production cost of a product over each functional block of the process can be easily obtained. Analysis results show that the largest exergy loss occurs in an exothermic reformer, accounting 60.4 percent of the total exergy loss. The exergy cost distribution diagram indicates that DMC has the highest exergy cost, followed by DME and methanol, and it is economically favorable to use the exhaust gas from the chemical synthesis block for power generation.

Process design and energy analysis on synthesis of liquid fuels in an integrated CCUS system

Liquid-phase CO2 Hydrogenation to Methanol Synthesis: Solvent Screening, Process Design and Techno-Economic Evaluation

A near-zero carbon emission methanol production through CO2 hydrogenation integrated with renewable hydrogen: Process analysis, modification and evaluation

Fuel Synthesis with Co2 Captured from Atmosphere: Thermodynamic Analysis

Systematic Design and Optimization of a Membrane–Cryogenic Hybrid System for CO2 Capture

Conceptual Design Development of Coal-to-Methanol Process with Carbon Capture and Utilization

Transforming CO2 into Synthetic Fuels: Modeling, Simulation, and Optimization Analysis of Methanol Production from Industrial Wastes

Techno-Economic Assessment of the Integration of Direct Air Capture and the Production of Solar Fuels

Liquid-phase CO 2 hydrogenation to methanol synthesis: Solvent screening, process design and techno-economic evaluation

Optimal design, thermodynamic, cost and CO2 emission analyses of coal-to-methanol process integrated with chemical looping air separation and hydrogen technology

Integrated CO 2 capture and conversion into methanol units: Assessing techno-economic and environmental aspects compared to CO 2 into SNG alternative

Study on the carbon migration from fossil fuel to liquid methanol by integrating solar energy into the advanced power system

Sustainable Biomethanol and Biomethane Production via Anaerobic Digestion, Oxy-Fuel Gas Turbine and Amine Scrubbing CO2 Capture

Enabling the Methanol Economy: Opportunities and Challenges for Heterogeneous Catalysis in the Production of Liquid Fuels via Methanol.

Carbon Capture and Storage Energy Consumption and Performance Optimization Using Metamodels and Response Surface Methodology

Modelling of an Integrated Process for Atmospheric Carbon Dioxide Capture and Methanation

A near-zero carbon emission methanol production through CO 2 hydrogenation integrated with renewable hydrogen: Process analysis, modification and evaluation

Process modeling and analysis of a novel system achieving near-complete utilization of captured CO 2 from chemical looping hydrogen generation

Analysis of integrated CO 2 capture and utilization via calcium-looping in-situ dry reforming of methane and Fischer-Tropsch for synthetic fuels production

A dual-gas sourced integrated methanol/DME/DMC catalysis approach to polygeneration energy systems design and an exergoeconomic analysis

Energy-environment-economy(3E) assessment of a novel low-carbon emission process integrating coal-to-methanol with green hydrogen