Abstract:Aiming at the problems of large dv/dt and di/dt in traditional single-ended converters and high electromagnetic interference (EMI) noise levels, a single-ended isolated converter using the secondary resonance technique is proposed in this paper. In the proposed converter, the voltage stress of the main power switch can be reduced and the voltage across the output diode is clamped to the output voltage when compared to the conventional flyback converter. In addition, the peak current stress through the main power switch can be decreased and zero current switching (ZCS) of the output diode can be achieved through the resonance technique. Moreover, the EMI noise coupling path and an equivalent model of the proposed converter topology are presented through the operational principle of the proposed converter. Analysis results indicate that the common mode (CM) EMI noise and the differential mode (DM) EMI noise of such a converter are deduced since the frequency spectra of the equivalent controlled voltage sources and controlled current source are decreased when compared with the traditional flyback converter. Furthermore, appropriate parameter selection of the resonant circuit network can increase the equivalent impedance in the EMI coupling path in the low frequency range, which further reduces the common mode interference. Finally, a simulation model and a 60W experimental prototype of the proposed converter are built and tested. Experimental results verify the theoretical analysis.

A Survey of CM EMI Modeling and Reduction Technique of Transformer for Isolated Converters

Modeling and Evaluation of Common-Mode EMI Coupling Through Converter Chassis in Metro Traction System

Research on Transient Electric Field Distribution of High-Frequency Transformers Based on COMSOL and SIMULINK Co-simulation

An Improved Impedance/Admittance Analysis Method Considering Collector Subsystem Transformation in Converter-Integrated Power Systems

RLC Balance Technique of Transformer to Reduce CM EMI for Isolated DC-DC Converters

Modeling and Design of a Medium Frequency Transformer with High Isolation and High Power-Density

Analysis and Suppression of Common-Mode EMI Noise in 1 MHz 380 V-12 V DCX Converter with Low NFoM Devices

Transformer Structure of Bifilar Primary Winding with Advanced Common Mode Noise Attenuation Performance for Isolated DC-DC Converters

ANALYSIS OF ELECTROMAGNETIC FIELDS AND EDDY CURRENT LOSSES IN LARGE POWER TRANSFORMERS

EMI Noise Cancelation by Optimizing Transformer Design Without Need for the Traditional Y-capacitor

Analysis and Reduction of Common Mode Current of the Transformer in a Full-Bridge LLC Battery Charger

Dynamic Electromagnetic Force Analysis of a Power Transformer with Regulated Windings

Modeling And Analysis Of Conducted Emi For A Modular Multilevel Converter

Magnetic Coupling Common Mode Conducted EMI Analysis and Improvement in a Boost Converter

The Electromagnetic Interference (EMI) affect on power supply of telecom equipment

A review on recent effort of conductive EMI suppression methods in high‐frequency power converters

Review on Modeling and Emissions from EMI Filters in Power Electronics: Inductors

Common-mode Electromagnetic Interference Mitigation for Solid-state Transformers

A Review of Radiated EMI Research in Power Electronics Systems

EMI Noise Source Reduction of Single-Ended Isolated Converters Using Secondary Resonance Technique

Research on Topology and Economy of High-Frequency Isolated AC/AC Converter in Fractional Frequency Transmission System